diff drain plug ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2003
Threads
319
Messages
2,206
Location
San Antonio TX
I was checking the diff fluids this weekend and the front plug came off w/o too much trouble, but the rear!!! I couldn't get it off with a socket so I purchased a wrench from sears. It doesn't seem to be the right size OR, only a 6pt will work. Am I missing something? Other than it possibly being a different sized plug which I doubt.

Thx
 
When you do get it off, install a hex head one from a newer Toyota.

90341-18021 Differential Drain Plug, Magnetic, 10mm allen ($2.03)
12157-10010 Differential Drain Plug Gasket: ($0.89)
 
Thanks for the tips. I will swap the plugs out when I get the rear one removed. Didnt have a 6pt 15/16 wrench that would work either. I'll swap the 24mm out for a 6pt tomorrow.

Thx
 
Sometimes, one end of a lug wrench works...
 
I always loosen the fill before opening the drain in case it doesn't want to loosen and your stuck without the vehicle until you can get it off or end up trying to use the small breather on top and measure it. The allen head is the way to go with this one also. The plug on the FJ62 have a very thin head that is easy to round off.
 
When you do get it off, install a hex head one from a newer Toyota.

90341-18021 Differential Drain Plug, Magnetic, 10mm allen ($2.03)
12157-10010 Differential Drain Plug Gasket: ($0.89)

Agree
 
Six point 24mm or 15/16 socket works.

:meh:
x2. 15/16 is 23.8125 mm so it is nice and snug in my experience

and take your socket to a grinder and get rid of the beveled lip. it grabs that skinny bolt a LOT BETTER.

x2. This is a nice tool to have in the box. Use a bench grinder and give your attention to keeping the face of the socket square to the side.


Also, I have used some heat and penetrating oil on diff/tranny/tansfer plugs but don't go crazy with the torch. Just try to heat the plug a little, let it cool, clean it up nicely, apply pb blaster, let it work for a while, heat a bit again, apply torque and it should come right out.

The newer 10mm allen plugs are quite nice.

Does anyone put anti-seize on these plugs?
 
I've had one so stuck on there I had to weld a smaller nut to the larger nut to get it off. The smaller nut was not as skinny and the socket got a better grip.

Replace with a hex plug and put anti sieze on...
 
I always loosen the fill before opening the drain in case it doesn't want to loosen and your stuck without the vehicle until you can get it off or end up trying to use the small breather on top and measure it.

haha yeah I learnt that one a long time ago :doh: :hillbilly:
 
The are interchangeable from 68 40s 55s through 87 60s and I thimk beyond as well. Are the 80s where Toyota started to spec the plugs that accept 10mm allen?


No, the 80 series, for the complete run in the USA, used the 24mm head drain and fill plugs.

:meh:
 
Finally got it loose. Going to dealer tomorrow to buy new plugs for front and rear.

Thx
 
Back
Top Bottom