Did I fry something?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

sleepycruiser

I will get by….I will survive
Joined
Aug 20, 2016
Threads
270
Messages
3,980
Location
Asheville, North Carolina
I hooked up a 4 channel amp and while I was putting everything back together I went to crank the LC and it won't crank. Lights are on, nothing turns over.....when I turn the key all the way the clock goes out....but it doesn't even try to start. So basically it is like I have all 12volt power but it won't crank.

Everything is grounded properly.
 
Check the 3 fusible links, you might have shorted something in the process which may have blown the link that powers that circuit.
 
How do I check to see if one of those are blown? Would I still be getting power to the radio, lights etc if one of those were blown?

Yes - do you have a test light or multimeter?

How about the EWD for your year 80? (Sigs do help)

Any chance you can jump start with cables & another car?

Also, unhook power lead to that amp - see if that "cures" something mysteriously.
 
This is the basics of the fusible links.

IMG_2193.webp
 
I have a multimeter....I will see what the battery reads.

I took the fuse out of the amp power wire at the battery to make sure there wasn't anything going on with that....but the amp is hooked up properly....only turns on when the key is engaged.
 
Attached right @ the battery.

Any chance you just didn't re-attach a terminal tight enough?

Did you / can you move them at all twisting with force?

Clean terminals? If not, clean & add a little grease, then re-attach terminal.

99% you bumped something or didn't tighten well enough, fusible links aren't fine china, so unless you jostled the battery or beat on one while threading your amp power line, give a good comb over anything you touched - I bet you skipped a bolt.
 
Thanks for the info. I took both terminals off and re-tightened them. I will clean them and see if that does anything. Just seems that if it was dirty terminals it would have been acting up before and at least try to turn over or give the 'dead battery spatter' noise.
 
I am an idiot. I took the ECU out from under the drivers seat because I thought it was for the factory alarm....which I don't use.....I was walking to get my multimeter and saw it and was like 'Hey idiot!! I bet that ECU is kind of important!'

What a dummy.

Thanks everyone for the info and feel free to throw tomatoes at me. ;-)
 
That is the factory alarm and it was doing it's job interrupting the ignition circuit. To remove it you need to get under the dash and unwire it.

I am an idiot. I took the ECU out from under the drivers seat because I thought it was for the factory alarm....which I don't use.....I was walking to get my multimeter and saw it and was like 'Hey idiot!! I bet that ECU is kind of important!'

What a dummy.

Thanks everyone for the info and feel free to throw tomatoes at me. ;)
 
We all skip a bolt/miss a part now & again - today was just your turn.

You should be good to go for awhile now since you manned up & owned it.
 
But delete that damn alarm system. Youll be glad you did.
 
There is a thread on it. Took me about 15 minutes.
 
Back
Top Bottom