Dash ‘movement’ on washboard.......

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2014
Threads
47
Messages
381
Location
Orange County, California
So out in Death Valley at the weekend and hit some pretty bad washboard. Tried to stay above it at speed which worked pretty well (cue debate) but at any speed my dash seems to shake and make what I think is a plastic on plastic squeaking noise.
As far as I know the dash has never been removed - is there a gasket between the dash and body that gets worn out or some bolts that need tightening up to stop/reduce this? I’m out there again in 2 weekends so will get some video.....
Thanks in advance!
 
if its the 95 in your sig its not so bad to pull the dash. i would take the cluster, radio and AC controls out and see if you can located where it is moving. there is no gasket or anything that wears out. dash rattles can be hell to find since the only real way to do it is tear into it and see whats loose.
 
I chased a dashboard squeak and discovered mine to be the windshield. If seal is old, or was not sealed properly (As is mine) then it will have some movement and squeak around its gasket. Mine is back to squeaking again :(. Good luck chasing that noise.
 
Thanks @MoJ
my search queries didn't pull that up!

windshield and gasket is new
 
if its the 95 in your sig its not so bad to pull the dash. i would take the cluster, radio and AC controls out and see if you can located where it is moving. there is no gasket or anything that wears out. dash rattles can be hell to find since the only real way to do it is tear into it and see whats loose.

It doesnt actually move if i try and move it with my hands/feet but get up past 20 mile an hour on washboard and you can see it moving - thanks for the tips!
 
It definitely could be the dash that is loose but it could be the windshield moving in the gasket. Very common issue with windshields that have been replaced and the installer didn't used adhesive inside and out.

I'll check it out when out on the roads next time - the installer did use the proper FSM method though - thx!
 
Back
Top Bottom