Dang IT! (1 Viewer)

Joined
Jul 30, 2006
Messages
436
Location
Inland Empire
My dilemma in mounting my Metal Tech Sliders that I just picked up. I have an extra bracket that was put on when I got my lift. Do I need it? I believe it is there to keep the caster? angle correct. Can I remove it and not effect the angle to bad? I have a 3 inch lift with J springs.
DSC07613.jpg
DSC07615.jpg
DSC07612 - Copy.JPG
 
Joined
Aug 17, 2005
Messages
5,650
Location
Forest Falls, CA
If you take it off, its gonna drive like *(*$#$%T. Just get Slee castor plates at a later date if you really need to put the sliders on.
 
Joined
Jul 4, 2007
Messages
809
I got some new castor bushings that I'm not using. They're FOR's bushings and I think they're for 3" lift.

You can give these a try and if they work, give me maybe $50 for them. If not, take them off and go for plates, Slee's or LT's.
 

Slomo

It's Complicated
Joined
Feb 8, 2006
Messages
3,175
Location
Behind the Orange Curtain
3" lift you would be fine with castor bushings or plates. If it were me I would sell the MAF brackets, get some bushings or plates and enjoy the extra ground clearance and Metal Tech protection. But that is just me. :grinpimp:
 

Users who are viewing this thread

Top Bottom