Custom door strikers- late doors to early tub

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Bump because the question is coming up again
 
Hey everybody... I just got a new batch of 20 sets. I was selling them at $15/set delivered but was actually losing money on the deal after buying padded envelopes and shipping costs. I'm not out to make money but am going to up the price to $18 a set shipped so I'm not actually upside down on these.

I'll respond to all the PM's in the next few days.

Please don't PayPal me until you've gotten a PM reply because quite a few sets are already spoken for. And I'm happy to make more sets but wanted to fulfill the ones waiting first.

Thanks!


IMG_3841.webp
 
Last edited:
Ok these shipped out this am except the Canadian guys. Shipping has changed since I last sent these so from now on these are unfortunately going to be $20 a set shipped and doubling up wasn't any cheaper. Sorry guys. Honoring the $18 price for original buyers.

And $9.50 to Canada?! WTF?! These are small little envelopes.

I'll try to send some PM's later for those not following the thread.
 
Ok it's clear the USPS is a total s*** show. No wonder they are bankrupt. 10 minutes later Canadian shipping is up to $15.50. The lady who quoted me $9.50 next to the guy I'm working with now looks over and doesn't give a f$@k.

Trump must've signed a new trade deal while I grabbed a coffee.

PM's inbound for the Great White Northerners.
 
Pics of the plates (with hoops added) installed.... If I had a super clean truck that didn't have original worn paint from 1973 I probably would have these plated. These are super stout and there's no wiggle even though there is leverage on them because they have to stick out.

(Sorry the last one isn't very good. Was trying to show it latched).


IMG_3887.webp
IMG_3888.webp
IMG_3889.webp
IMG_3890.webp
 
Were made from a set of rusted out full doors. It was a 10 year project with the first 5 years sitting on the shelf. Then cut off the tops, sat, fabed a cap, sat, fabed lower replacement pieces, sat, spot welded one cap on, then finally took them to a buddy who cut off the bottoms, made new pieces and capped the second one all in a couple hours. Ha ha.
 
Back
Top Bottom