Cowl vent block off

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 3, 2002
Threads
370
Messages
3,594
Location
NoCo
Is there any pre fab cowl vent block off plates out there? Or, is anyone making them?


Thanks



devo

FEA9F70B-B806-4935-AA83-875DC9400C01.webp
 
I forgot about SOR? I’ll look it up.
Also thought about a full rubberized seal for under the vent grates. But water would then sit on top of the rubber under the vent!
 
I forgot about SOR? I’ll look it up.
Also thought about a full rubberized seal for under the vent grates. But water would then sit on top of the rubber under the vent!


Plus dirt , leaves, pines and who knows what else that would help hold moisture in. It would also not be that easy to clean out. On a 74-76 model with the dummy vent welded shut would use a solid plate. Mid 65-73 would just deal with the louvered plate to keep the operational vent.
 
SOR stainless. I just scuffed with some sand paper, primed, and rattle canned it. No clue how it’ll hold up. I need a better gasket idea. I used some general weather stripping from a big box store.

10CD1905-4FE3-4290-98C2-A593E6A22B6B.jpeg
 
Last edited:
@devo saw mine on the Karma Cruiser when I was in CO last July. Bare aluminum.

I’m sure my cnc guy still has the template if others want some.
 
What'd you make that out of?

I need one and was going to order one from SOR, but I don't want stainless because I'm not sure how to properly prep stainless for paint.

11ga carbon
 
Mark, yes been thinking of your block off plate since you drove off into the sunset.❤️❤️

I’ll definitely take one if you can make it happen? How many people need to want one?

Thanks,
 
‘74 has the vent whole but it’s nonfunctional. I left the drain tubes and added a 1/16” piece of aluminum under the grate. After 10+ years I’ve not had any problem with debris or moisture being trapped under it.

I don’t remember if I put silicone under it or not. The drain wholes under it will ensure that water won’t buildup underneath it.
 
In my case, I have a 76 cowl and a 74 trans cover. In 1976 the drain holes were in the trans cover, and in 1974 they were in the firewall. So in my case, I have no native holes and would rather not drill at this point for a non-functional part. Thats why I went the route I did.
 
Back
Top Bottom