Console me...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 5, 2005
Threads
116
Messages
1,273
Location
Calgary
My HG pm and SC install are done and I want to use the truck for my family's annual vacation. We tow a 1700lb tent trailer and will be heading through several mountain passes to get to the west coast.

Some of you may recall that I had an overheating problem right after I finished bolting everything up. That was solved by installing a new fan clutch, new '94 rad, new non-ringed fan and redoing the coolant flush by filling from the heater hose by the heater valve on the firewall. Indeed, its true, your cooling system must be in top condition with a supercharger. I would like to add a point of support for Dans research on the non-ringed fan solution: that 3.0l v6 fan pulls significantly more air than the ringed fan.

We have been driving the truck for a week now and the temp gauge hangs just below half and does not budge. I have not had time to do the temp gauge mod however. As well, there are no leaks, and no wierdnesses of any kind. The idle is stable and no codes.

So here is my question. I dont have to take the cruiser on this trip - we have a 4 door pick up that could do the job too. The problem is that I am having doubts about the competence of my work. Aside from scanning for leaks and paying close attention to the behaviour of the truck what else can I check to reassure myself that I am not just a :banana: guy posing as a :banana::banana::banana::banana: guy?

Karl
 
We have been driving the truck for a week now and the temp gauge hangs just below half and does not budge. I have not had time to do the temp gauge mod however. As well, there are no leaks, and no wierdnesses of any kind. The idle is stable and no codes

How about dropping a little more coin and getting a Scangauge II?

I assume you can get one shipped to Canada and that it will work (no idea why it wouldn't)...

I'm sure you know all about the limitations of the stock temp gauge so the Scangauge IMO is worth the investment for the WT measurement alone and adds a lot to my piece of mind.

And x2 on Gas' recommendation...Take some time and do some towing tests - flats, hills, idling, etc. and see how the rig does close to home before venturing out.
 
I have an aftermarket temp gauge and it came in handy on the way to Moab when I started overheating. The gauge gave me enough notice to slow down and shut off the AC and when it stayed hot and then started to creep up, pull over and allow it to cool down.

Turned out I had a opinprick leak ion the coolant hose coming down from the throttle body and had slowly lost collant.

After it cooled I added water and it drove fine until I had a chance to replace the hose.

Key thing is to have a Good temp gauge that is always visible so you can react. I isntalled mine and a boost gauge on the drivers piller. The temp gauge is more important as to health. The boost gauge shows when the SC is doing something and how well.

I noticed the stock temp gauge ddin't move until it was allready too hot.
 
I noticed the stock temp gauge ddin't move until it was allready too hot.

x2 on that...

Coming back from Moab, dragging a 3500# popup camper and a weeks worth of gear and family members up Vail pass and then up to Eisenhower tunnel, my non-supercharged LX was only able to muster about 20-25 mph.

Slow, engine working hard, tranny working hard (i.e. additional heat up front with the tranny cooler), and I started to notice a rise in temperature. Per my Scangauge II it wasn't until the LX reached ~215F before I saw even a slight movement on the stock gauge. Max temp I saw was 225F right as I reached Eisenhower, at which point the stock temp gauge was only indicating about 2-3 needle widths above horizontal (typical resting place on mine is 1 needle width below horizontal).

Luckily for me it was cool that day and actually had rain/snow. Probably 40-50F outside temp. If it had been an 80-90F day :eek:

Bad time to wish I had replaced the fan clutch before the trip as folks (including Romer) had suggested as part of base lining my rig after purchase.

Anyway, bottom line IMO is mod the stock gauge or get a secondary more accurate gauge whether it be in a pod with a boost gauge like Romer since you also have a SC, or a Scangauge II or just a gauge velcro'd to the dash for the time being :D
 
I noticed the stock temp gauge ddin't move until it was allready too hot.

X100,000,000

I am really glad I installed my gauge prior to towing our boat to Colorado. it gives you enough warning to kill the A/C or turn the heaters on till you can find a spot to pull over long before the stocker started to move.


Dave
 
How about dropping a little more coin and getting a Scangauge II?

Corsair, would you mind sharing some images of how you have your scangauge mounted. I am about to install a Sirius Sportser4 (I want a more integrated look than sticking it to the windshield) and want to leave room for one of these guys.

Thanks.
 
Corsair, would you mind sharing some images of how you have your scangauge mounted. I am about to install a Sirius Sportser4 (I want a more integrated look than sticking it to the windshield) and want to leave room for one of these guys.

Thanks.

Sure, but you wouldn't be impressed :lol:

Basically I'm REAL slow at mods so for now I simply have the unit sitting right behind the steering wheel, right in front of the gauge cluster, sitting on top of the steering column. I have the cable plugged into the OBDII port and then looped up over the steering wheel, across the shift console, and then back to the Scangauge.

I haven't decided on where I want it "permanently" mounted. I thought about mounting it in front of the little slot above the radio (where some folks have installed the cup holder) because that slot is pretty much useless and size wise the unit is just slightly bigger than the slot. But, it is hard to read in that location. Other spots I considered are on the little sections of dash above the stereo or above side mirror controls but mounting there would block a vent.

I'm thinking the best place is right where I have it now and honestly you don't really have to even attach it (the company recommends taking it out when the temp is real cold or real hot). With the way I have my steering wheel/column set the Scangauge sits in position perfectly and doesn't move unless I hit the cable. I've been to Moab 4wheeling etc. and it didn't move once. And, it is easily read when right in front of you. I'll probably unscrew the OBDII port so I can tuck the plug in and put the cover back on and then route the cable better so it is hidden more down the road...Someday
 
I would personally take a different approach. First I would ask myself how solid is my marriage? Second I would imagine that I was my wife and we are in the middle of a annual vacation and the truck my husband spends night and day working on and spend his spare moments online talking to other people (who knows maybe a secret girlfriend) online about this truck suddenly breaks down in the middle of nowhere? Third do you want to p**s your wife off because your spending your whole time looking at your gauges and not watching the road (insert picture of post with Subaru flying thru the air at some poor kid but replaced with your beloved land cruiser in the background and you s*****ng your pants, posted on recent rollover post)? Last do you have plenty of tools and CDANS phone number etched in your dash with a good relationship with him and lots of in stock parts luck?
If you want a divorce, sleepless nights or hopefully if all goes well a big ass grin when you return with no problems. Go for it and don't look back what the hell you only live once!
If you want to continue your marriage and be bummed you didn't go for it take the truck. What are you crazy????
GOOD LUCK this of course is coming from someone who has experienced some of this but in no way offers professional advice.
Oh ya I'm a :banana: when it comes to the marriage thing so take it for what it's worth. I would take the 80!!!!!!
 
I would personally take a different approach. First I would ask myself how solid is my marriage? Second I would imagine that I was my wife and we are in the middle of a annual vacation and the truck my husband spends night and day working on and spend his spare moments online talking to other people (who knows maybe a secret girlfriend) online about this truck suddenly breaks down in the middle of nowhere? Third do you want to p**s your wife off because your spending your whole time looking at your gauges and not watching the road (insert picture of post with Subaru flying thru the air at some poor kid but replaced with your beloved land cruiser in the background and you s*****ng your pants, posted on recent rollover post)? Last do you have plenty of tools and CDANS phone number etched in your dash with a good relationship with him and lots of in stock parts luck?
If you want a divorce, sleepless nights or hopefully if all goes well a big ass grin when you return with no problems. Go for it and don't look back what the hell you only live once!
If you want to continue your marriage and be bummed you didn't go for it take the truck. What are you crazy????
GOOD LUCK this of course is coming from someone who has experienced some of this but in no way offers professional advice.
Oh ya I'm a :banana: when it comes to the marriage thing so take it for what it's worth. I would take the 80!!!!!!

Oprah's in the house!
 
Well my wife found something that prevents us from taking the cruiser. Yesterday I had the AC recharged. It was working great. While I was setting up the last bit of wiring for the trailer she pointed out a small spot of green stuff. I went and looked and it was r134 dripping on the floor. The leak is coming from the high pressure hose at the clamp where the hose passes through the grill. There is a tiny pinhole leak due to corrosion. The likely hood that I can get a hose and get it recharged before our planned departure is near zero. Oh well, we still have a few trips planned later in the summer. Thanks for your input guys.

Karl
 
:lol: does this mean I can write a check for a gazillion dollars and not worry about it clearing?!?!?! SWEET

No, it means you owe us all a new car! :cool:
 
Hey Karl, good luck on you trip to the left coast; at least you have the option of another vehicle. On the other hand, my naturally aspirated 80 seems to be behaving normally and hopefully will be a steadfast performer on our upcoming trip east. Typically, after I get more than 20 or 30 km from the house, I have to admit, I get temp gauge paranoia. That said, the new tent trailer is less than 1000 lbs. loaded, so I doubt the stress will be prohibitive. Have a safe trip and take care, Greg.
 
Back
Top Bottom