clocking toyota transfer case

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 17, 2006
Threads
500
Messages
3,171
Location
Santa Rosa, CA
I have an fj60 transfer case ('84) in my 40. It's been converted to 4:1 gears by AA, so I'd like to keep it, but it hangs way down. I searched, but could not find anything on clocking rings. Can you clock/rotate the transfer case up to gain clearance? The thing is a giant rock catcher. It's mated to a 4l80.

good pictgure.webp


0asdfa.webp
 
Try driving around the rocks. ;)
 
which adapter do you have for the 4l80 to split case? If it is the typical round GM connector at that location, It's a fairly simple process to rotate the transfer case and drill new holed in the adapter plate. Or having a flat 1/2" plate machined with the holes offset. Any competant machine shop would be able to kick that out in no time. The bigger issue is that if you do that, you'll need to change a LOT of things in the truck to make it work out. It looks like you'll have floor pan interference, a worse angle on the rear driveline, you'll need a new crossmember and skid plate. That's not to mention the shifters and controls...
 
I’m no expert on conversions, but Jim @Downey told me many years ago that the front flange of the tcase is usually hella close to the auto trans pan.

Ho much room do you have between your flanges and your trans pan?
 
[/QUOTE]
I’m no expert on conversions, but Jim @Downey told me many years ago that the front flange of the tcase is usually hella close to the auto trans pan.

Ho much room do you have between your flanges and your trans pan?

I agree. As you clock the t-case you are going to get into internal/external portions of the trans that are not as easy to 'trim' as the pan. On a 4L60e/5.3 setup with a AA adapter, there would not be enough gain to be worth the effort.
 
Thanks for all the great input. I have 14" to 15" inches clear right now to the skid plate. I'm looking at doing a 4 link in the rear in a couple of months as part of going to 40's and lengthening the wheel base (102"?). I'm trying to plan everything out, and one thing I want to achieve is more more clearance underneath. I guess one advantage of an atlas is it sits flatter. Since I going to new axles, this is the time to change to center and driver drop - if I'm going to do it.

I had been thinking about changing the t-case for strength, but got made comfortable the split case is strong enough. But maybe clearance will be the deciding factor.
 
An Atlas t-case is definitely easier to clock.
 
I have 21" under mine. But have an Orion. Still SOA with 375/75 R16. I did ad 1/2" spacers to allow the t-case to come up a bit.
Trans Install 9.webp
 
I'm still SUA, I'm going up enough to go from 37's to 40', so I'm figuring about 3" (because it's really tight right now). So, not as much as going SOA. That puts me at 17" to 18". I WANT MOAR. If I got to a body lift - and I've had people tell me to never do it - I'll spend many, many hours redoing the roll cage mounts that sandwich the body on their way to the frame.

I'll look at moving the transfer case mount up, I'm not sure how much angle the drive train is at now.
 
I'm still SUA, I'm going up enough to go from 37's to 40', so I'm figuring about 3" (because it's really tight right now). So, not as much as going SOA.
Well, there you go...
 
Back
Top Bottom