CDL Switch problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 13, 2006
Threads
9
Messages
20
Location
Minneapolis, MN
My CDL switch was bad (confirmed) so I put in a new one and it still does not work. Now if I manually push the ball or short the wires on the switch, I can see the ABS and Diff Lock lights come up on the dash. I have installed it with and with out the washer. Any ideas? Thanks!
 
Last edited:
You talking about the switch on the Tcase?
 
Let's clairify.

The CDL switch is in the instrument panel. You are referring to the position indicator switch.

If you can manually press the position indicator switch (switch removed from transfer case) and the dash lights come on, the difflock actuator is not operating.
 
Yes,

Been working on it this afternoon. The diff lock actuator is indeed not working. I cannot hear it trying to work either. Looks like I need to check the center diff lock control relay, or the cdl switch or the motor. Problem is my My 93 FSM only covers w/o ABS for some reason. Any ideas welcome.

Thanks!
 
OK, so I tested the actuator with a 9V battery and could hear it move. Good news!

So, I then did the FSM tests for the CDL control relay (transmission relay) and it failed the test between pin 6 and 7. I tried both ways with the meter since there is a diode between them. It passed the other tests. I inspected the relay board and soder joints and it looks good.

Anything else I should check before I go and buy a new CDL control relay???

Thanks!
 
Back
Top Bottom