build: 71 FJ40 “Stripes”

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Wise words indeed.

I was encouraged by your results. I added 2 more degrees, and set the timing at 10 degrees. And reduced the idle speed just a little. My hesitation is nearly gone now.

What is your idle rpm set at? I set mine about 600. I wonder if your idle speed can be set lower, to avoid the possibility of pulling fuel from the main circuit at idle. Might be something to mess around with.
It should be at 650.
 
My internet is bad right now so it’s tedious to go back through your build, but is this the F motor or the 2F you mentioned at the thread beginning? I ask because I’ve seen that 650 rpm suggested a lot, and I have my F set around that, but the F-Engine Repair Manual says ignition timing is 7-deg BTDC at 500 rpm’s. Don’t know what the 2F timing specs are in the appropriate manual for it.
 
Yup, that’s what the F engine manual states.
B34C202A-4C1F-400E-A1CA-4894DE9D4A37.jpeg
 
My internet is bad right now so it’s tedious to go back through your build, but is this the F motor or the 2F you mentioned at the thread beginning? I ask because I’ve seen that 650 rpm suggested a lot, and I have my F set around that, but the F-Engine Repair Manual says ignition timing is 7-deg BTDC at 500 rpm’s. Don’t know what the 2F timing specs are in the appropriate manual for it.
Yikes, yes it is an F motor. I don’t have the fsm. But ok.
I don’t think I can get her that low but I will certainly try. Waiting on some plugs and wires to complete my tune up. And try to dial it in.
Thank you
 
Hey all !
So I am still dealing with a misfire on my FJ40. And I saw this on the ammeter while it is at idle and while I give it gas.
Is this a possible regulator problem? Or alternator ?
When I measure it with a volt meter I get the actual 14 volts from the meter.
Input welcomed thanks
At idle

At a higher rpm.
 
Looks like you're enjoying it!

Take a second and wipe the finger prints off the lens of that camera for our viewing pleasure :grinpimp:
 
Looks like you're enjoying it!

Take a second and wipe the finger prints off the lens of that camera for our viewing pleasure :grinpimp:
I am just in spurts. Having trouble with idle very frustrating.
My Lens on my phone is bad I have cleaned it.
Just need to invest in new phone.
Thanks though.
 
Got home today from working on a friends FJ60. I get a call from GF that a Tesla made too wide of a turn and caught the bumper on the 40 series. Didn't go so well for the Tesla.
FYI the bumper on the 40 was just chipped paint. 😂

Resized_Resized_20230211_175253.jpeg
 
Got home today from working on a friends FJ60. I get a call from GF that a Tesla made too wide of a turn and caught the bumper on the 40 series. Didn't go so well for the Tesla.
FYI the bumper on the 40 was just chipped paint. 😂

View attachment 3246100
Probably set all their sensors off too!! :)
 

Users who are viewing this thread

Back
Top Bottom