Broken bolt extraction question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 30, 2003
Threads
19
Messages
1,081
image.webp
I've got a broken bolt I'm going extract, but need some advice. The bolt is in the firewall end of the intake manifold and stands about 1/16" proud. I'm going use my tig to build it up and weld on a nut, but I'm worried about the localized heat cracking the cast iron. Should I preheat it, or is it not an issue?
 
I would just drill it with progressively larger cobalt bits. I have never had much luck welding nuts on really stuck steel bolts in either steel or cast iron and putting much force on them. It usually just twists the welded nut off. Drilling will work if you can get a drill into position.
 
Not an issue...if anything... the heat will help break the corrosive bond between the threads and the cast iron.

You can HEAT cast iron almost as quickly as you like (but the small bit of welding on the bolt isn't going to transfer much heat). What you don't want to do is COOL cast iron quickly.
 
Welding a nut "should" do it. Clean the area thoroughly before welding. Apply the heat to the stud and swirl the weld out to the nut. Build it up to the top, before it cools tap on the tap a bunch on the nut. Once it cools try to loosen it, if no luck try to tighten. It should break free with the back and forth method .

Good luck
 
the welding of the nut works prettygood but you will probably need to heat the area where the bolt is broke off or you will just break it again good luck
 
I have had good luck with progressively larger left-handed drill bits.
 
if you heat the part where the bolt is in it will come right out with the welded nut if not something will break
 
Wow! Thanks for all of the advice. Sorry about the iron bit, it was late and I wasn't thinking hard about what I was writing. It's an '82 so it's definitely aluminum. My default method with broken bolts is to flap disk the top flat and drill down a small hole in the center, and then use the TIG to build up a post and then TIG-weld the nut on. This has always worked great for me, whereas doing it with the MIG has not--the nut always breaks off. I'll go ahead and not worry about the localized heating of the manifold.
 
Back
Top Bottom