Brake (I think) Vibration Issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 2, 2004
Threads
178
Messages
1,417
Location
Athol, MA
Brake Vibration Issues

I have a 1997 that I am trying to solve what I think is a brake caliper or rotor causing vibration. I've replaced the front discs with OEM Toyota, new calipers and 100 series pads. The front wheel bearings were completly cleaned and repacked using LandTanks method. I feel a "pulsing" of the brake peddle when I apply the brakes. The rear pads have plenty of pad left, but the discs are not new. The rear bearings were repacked several months ago. Could I have a warped rear disc and could this be causing this pulsing feeling? I am willing to replace them if this would cure the problem. I just want to eliminate all other possibilities.
 
Last edited:
Hvae you tried having your tires balanced?


May not be it, but worth trying
 
I think I have the same problem...I had a seized e-brake a while back and have had that symptom since. I plan on replacing and going through the rear soon enough. I still need to do the rear t-case seal and bearing first...

*sigh*
 
I just ordered the rear rotors. I sure hope this is the cure. It very likely could have been a stuck E brake shoe. When I pull up on the handle the E brake will engage. When I release it, the cam does not go back against the brake backing plates unless I tap it back with a hammer. While I am replacing the rear disc I guess I will take a look at servicing the E brake and its cam that I have heard is a cause of some problems.
 
Well, the rear rotors are on and the vibration is gone. By the looks of my E brake hardware I'm almost sure that the E brake pads were stuck at some point and over heated the disc/drum. I took all of that hardware off and will be calling Dan to get all the small bits to rebuild everything. Now I just have to get my new LSPV adjusted correctly. No matter how hard I stomp on the brake pedal it is hard getting my very heavy Michelins to lock up. Trial and error should resolve that issue.
 
Grunt, another culprit could be material build up on the rotors from not seating new pads in correctly. I had the same pulsing issue and ended up taking the rig out on a deserted stretch of road and "re-seating" the pads. Got rid of the pulse.
 
I slid the new LSPV down as low as I could on the bracket. I also raised the mounting point on the axle as high as I could. I raised it to the point that the long rod has about 1/2" before hitting my upper control arm. With Slee 6" coils I think the only way to find out if the adjustment is correct is to have someone put gauges on in place of the bleeder screws as set it up that way.
 
I'm on my way today to buy some Dynabeads to throw in the tires. The Michelins are very well balanced when new, but as they wear this is not the case. I have heard and read only positive things about the Dynabeads. The pulsing went away now that I have all new brake calipers, pads, and rotors. I still have a very, and I mean very slight vibration that I attribute to balancing. I'm looking forward to seeing how these beads perform.
 
Back
Top Bottom