AOE bumper group buy???
- Thread starter socallove
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #502
Yea.................. That was exactly what I thought, but then I laughed out loud instead while he was on the phone.
I got my receptacle on Tuesday last week!
It isn't anything too special, just a STP part from West Marine.
It isn't anything too special, just a STP part from West Marine.
Sorry, Wrench, I had a lot of issues and made several calls and sent a couple nasty emails. He sent my stuff after I wouldn't leave him alone about it.
I still never got everything, but whatever. I got the important stuff. Eventually I'll throw the old toyota logo on the backing plate and bolt it on the outside of the bumper and cover his logo. Then I'll feel better about it.
I still never got everything, but whatever. I got the important stuff. Eventually I'll throw the old toyota logo on the backing plate and bolt it on the outside of the bumper and cover his logo. Then I'll feel better about it.
I am leaving the signals due to unplugging them causing the rear to blink rapidly. I am splicing a nice LED signal into the wiring and seeing how that works out. I will post pics later. I did have to cut the center of my lower cowling and grill to make room for my winch. While I have the bumper off I am boring out the lower mount holes on both outer sides due to mine not lining up.
I installed 3 small LED lights instead of 1 larger light. They work great. They are bright, I wired them directly to the signal wires. Hardly any power draw at all.
Neat idea!
Sent from my HTC6500LVW
Sent from my HTC6500LVW
Wrench, I don't think Alex has a plan for that. I'm not sure he has a plan for anything. Too bad, because it IS a really nice product.
Just a thought, but I bet you could drill a couple holes, add some spacers and a couple bolts and mount directly to the front.
If you're really clever, you could mount it with spring loaded hinges and use it to cover the winch hole. Flipped up when using the winch, flipped down when cruisin'
Just a thought, but I bet you could drill a couple holes, add some spacers and a couple bolts and mount directly to the front.
If you're really clever, you could mount it with spring loaded hinges and use it to cover the winch hole. Flipped up when using the winch, flipped down when cruisin'
Use Maglite flashlight mounts. You can use them to mount to any tubing, even a fairlead
soooo did anyone receive their decals or 12v outlets???