AC Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 29, 2007
Threads
102
Messages
759
Location
S. Jersey - New Germany
My AC runs nice and cold but every once in a while it seems like someone turns it off while it's blowing cold air. It immediately blows hot air until I hit the OFF button and then press the HIGH button. After I do this it stays on and works fine. Has anyone else had this happen or is my Cruiser possessed?:bounce2:
 
Last edited:
Overheating doesn't seem to be a problem. My temp gauge is always in the same place. Why would it run OK after I turn it off and on?
 
Are you saying that when it acts up, you only have to do this procedure *once*, and then it will work fine indefinitely and/or for the remainder of the trip?

If so, then I agree that the advice so far is on the wrong track.

Curtis
 
Are you saying that when it acts up, you only have to do this procedure *once*, and then it will work fine indefinitely and/or for the remainder of the trip?

If so, then I agree that the advice so far is on the wrong track.

Curtis

And, there doesn't seem to be any pattern. I has done it when I have been only driving for 5 minutes and sometimes when I been on the road for a half hour. It doesn't do it all the time when I use the AC either. It just makes me wonder if something is going to fail one of these times because it's not normal.
 
Similar thing happened to me. The AC would work and then warm air. I'd shut it off and then turn it on a few minutes later and it starts to work. The temp gauge stayed at the same place. Sometimes it seemed to work indefinitely and other times after 20 minutes. Finally, I pushed it up a hard hill and I saw the temp guage move slightly. Checked out the AC and everything seemed fine. Pressure was good and didn't need to be refilled. Changed fan clutch, did coolant flush, changed t-stat. Nothing worked until I finally changed out the radiator. Now no more problems. Even though your temp gauge might not move, may still be an overheat problem.
 
Overheating doesn't seem to be a problem. My temp gauge is always in the same place. Why would it run OK after I turn it off and on?

I'm not sure how the AC override operates, but knowing there is one and it's tied to engine temperatures, it's the first and easiest thing to rule out. Now that I've coaxed that extra tid bit of info out of you, hopefully it will help narrow the focus.
 
Now that I've coaxed that extra tid bit of info out of you...

Rod,

Rookie's right, we really do need more precise info. For example are you doing what cooldry described? That is, turn it off for a few minutes?

Or are you doing what for some reason I thought you meant, which is simply hit off, then high, all within a second or two, and then it's working again?

Tell us exactly...

Curtis
 
Sorry if I'm not giving you all the info need to solve this problem. If I knew all of the info to post for this I would probably know the answer. This is why I posted the problem, because I don't know the the answer. What may seem very obvious to you guys is obviously not to me. So if you can, have a little patients and help me get through this. It's hard enough when you don't have any help, this site and you guys have helped me through many problems already and I hope to learn and help others with all that I have learned.

Now, the only other info I can be specific on is it the amount of time it took me to push the OFF and HIGH buttons. I not sure exactly how much time it took but if you took your index finger and pressed one of the buttons and then without hesitation pressed the other button, that is how long it was between the two steps.

I hope you have a sense of humor too.:beer:
 
I'd just continue pushing the buttons until it quits for good.

If you can, pull over next time when it quits and see if the hub on the compressor is turning. If it isn't, you have an intermittent electrical problem. I'd look at the AC relay first.....
 
Overheating doesn't seem to be a problem. My temp gauge is always in the same place. Why would it run OK after I turn it off and on?

Have you modded the temp gauge yet with the raventai mod so it actually works? If not, you could be overheating, the gauge doesn't move until after the A/C cuts out.
 
Also, did you check the little window that shows how much "freon" you have? You may be running low. After going through what I went through, I would first check to make sure the AC is working fine before looking at overheating. Have the pressure checked to see if it needs to be refilled. Also, if it's just a matter of flicking the max button for a second, it doesn't sound like it's that much of a big deal. You could drive around like that until it gets worse and see if something obvious shows up.
 
Pushing the button is definitely workable and cost effective. I was just hoping that someone had a similar problem. I not ruling out it could be a temperature problem but it has happened both when the engine is cold and when it is hot. I definitely will check if the AC pulley is engaged when it happens again.

If the pulley isn't turning while the AC is running (when this happens) can I assume it is the Clutch or the AC Relay?

Trying to be a detective about this leads me to believe maybe the Relay? Is there a way to check the Relay?
 
Also, did you check the little window that shows how much "freon" you have? You may be running low. After going through what I went through, I would first check to make sure the AC is working fine before looking at overheating. Have the pressure checked to see if it needs to be refilled. Also, if it's just a matter of flicking the max button for a second, it doesn't sound like it's that much of a big deal. You could drive around like that until it gets worse and see if something obvious shows up.

I don't think it is the Freon although I will check it. I just recharged the system a month ago and even when the problem occurs it almost seems that when I get the AC to work again it blows very cold air, even colder than before it turned off.
 
I don't think it is the Freon although I will check it. I just recharged the system a month ago and even when the problem occurs it almost seems that when I get the AC to work again it blows very cold air, even colder than before it turned off.

Who recharged the system? It is very possible that you have an overcharge and that the excessive pressure is shutting things down.......


BTW, this is pertinent info that belongs in the first post....
 
Who recharged the system? It is very possible that you have an overcharge and that the excessive pressure is shutting things down.......


BTW, this is pertinent info that belongs in the first post....

STOP already with the "pertinent info" line. Help a fellow member will ya.


I guess anything is possible but the charge kit I used had a gauge on and I stayed within the area (on the gauge) recommended.
 
which guage? low side or high side?

I think pressures are your problem...too much and you are locking up the compressor. Don't be too sensitive...ticking you off just answered your question :)

Take it to an AC person, $5 says you have too much high side pressure since you put the recharge on the low side.
 
which guage? low side or high side?

I think pressures are your problem...too much and you are locking up the compressor. Don't be too sensitive...ticking you off just answered your question :)

Take it to an AC person, $5 says you have too much high side pressure since you put the recharge on the low side.

The High and Low ports on the AC for filling to are different sizes. It would be impossible to use the wrong port. PM me and I will tell you were you can send the $5.

The guage I'm speaking of is the guage on the hose of the recharge kit.
 
Back
Top Bottom