Okay, my rig has been running at about 1000 rpm since I got it running several years ago. I get terrible milage (around 8 to 10) and have been putting work into it trying to get it up to snuff. I have done several camping and road trips with it and have not had any real issues other than poor...
My TPS sensor was replaced at a local shop, but I do not believe they set it up correctly. They didn't have a manual, and it turns out that they didn't know as much as they said they did (long story).
I have a blinking OD/OFF light; the error code refers to the TPS sensor. I'm also getting...
Hi all--Chasing a P0125 on my 1996 LX 450. It was intermittent, then the other week it became permanent and the truck started to run very rich (by smell), rough, missing, etc. Checked upstream O2, found signal wire hanging by a corroded thread, replaced the harness side connector.
Started it...
Hello all,
How on earth do i remove the TPS from the injection pump? I cannot remove the screw closest to the engine. Is there a special tool?
Ive developed shifting issues after an injection pump rebuild (very late shifts, extremely sluggish) and i suspect the TPS was reinstalled incorrectly...
Finishing up my boost compensator install and came to the portion where I need to install the Throttle Position Sensor (TPS). The FSM states I need to supply 5v to terminals VC and E2.
My question; Whats the best way to supply 5v? Or is there a better method?
Does anyone have a source for this connector—the side that clips into the TPS sensor harness? Otherwise, I'll just have to source one form another LX/LC.
I have 4 TRD Pro wheels with center caps and TPS mounted with 265/70/17 BFG KO2s with less than 4 months of highway use. Purchased February 2022 and removed in May 2022. Never off highway. Excellent condition. $1500.
I have a question about a FZJ80 series to 1HDT (1HZ or 1HDFT) diesel and manual transmission swap and how it relates to cruise control and TPS.
I know on some early model manual transmission HDJ80s, the trucks did not have a throttle position sensor on the injection pump even though they had...
So I have been fighting a code 41 after a full rebuild on engine. Pulled off the throttle body and tested the TPS on bench and adjusted per fsm. Then installed on truck and tested to the ECM per the fsm. Everything is in spec. Now I did have to replace the harness clip to the tps. I checked with...
2016-2021 Toyota Land Cruiser 4 rims with 4 new valve stem assy (TPMS sensors), 4 factory center caps, and 20 factory lug nuts. Great upgrade for your early 200 series or upgrade your 100 series. Wheel size 18 x 8, bolt pattern 5 x 5.5, offset 56. Prefect condition.
$1,000.00
No shipping...
Hi, I'm new to the land cruiser world. I've stumbled across this forum and am loving it.... I have a 97 FZJ80 with factory lockers. Truck has 212k miles. I recently got an issue with a fluctuating high idle. (Between 1500-2200ish) I decided to drive the truck as it was hoping something would...
Does anyone know the thread pitch and length of the 1FZFE TPS sensor screw. 1997 year model if it matters.
I’d take the part number for the OEM replacement screw too if you had it laying around.
The cool kids on the 60 series forum replace theirs with allen head screws...
Thanks
Hello everyone, after looking around my engine bay I noticed the bottom screw of my tps was missing, And the top one was tightened down causing it to kind of lever outwards. So I tried to adjust it using a digital multimeter set to ohms. I used a 0.93 mm feeler gauge between the throttle stop...
Got a 41 code the other day on my '91 along with rough running/loss of power followed by sudden return of power. Pulled TB to clean (fair amount of carbon build up), and TPS to test. Set up TPS according to manual (was about a hair off at 0.93mm between IDL-E2 - set, tightened screws, and...
Had a light rough idle on my 1993 80 series took it to a mechanic and he narrowed it down to the IAC, specifically the O-Ring. He recommended that I fix the issue myself by ordering the part. He also recommended me to change the TPS sensor on my car because the one that came with it was not OEM...
Hey mudders,
Having what I believe is a throttle position sensor issue, but I’m not sure...
Here’s what’s going on:
My car started and was running fine per usual, then I hopped on the interstate and floored it hard until I reached about 85mph. I turned off of the interstate and floored it...
1997 FZJ 80 145k miles
About 1 month ago I cleaned my MAF sensor because I had an intermittent miss at idle and around 1800 RPM while driving. Everything was fine for a day, until the miss came back along with code po120. The 80 also began to accelerate poorly when cold. After it warmed up, the...
Hey Guys,
Been having the same code come back after a few weeks and loosing throttle. Anyway I'm getting ready to get the part but trying to decide if I should go Toyota genuine OEM or Denso. I know Denso made the original but if this sensor is a problem does that mean buying an original...