Ok Installed the wiper relocate as you all may or may not not Know, and had purchased a bad spray motor, just installed the new one and viola wiper wash works, BUT It dosent even reach windshield, Now I know there is one more part other than the small12v pump on bottom of resevoir. and know the...
1991-97 Land Cruiser / Lexus LX450
Slee Rear Bumper with Dual Carriers, Jerry can basket, and Hitch Accessory mount
Part: SOF1306
Can deliver within a few hours of Phoenix. Minor scratches but in really good condition. Trail-vise and propane not included
SOLD
Jeff
Just pulled the trigger on a set of slee steel skids. Wondering if I'll have to notch the belly pan skid in order to clear the ubolts.
Anyone have this setup? How was the install?
Thanks!
So it turns out this very hi quality kit to move your wiper resovoir, works really well. Botls right in. nice. EXCEPT if you have a TRD supercharger, if you do then the MAF on the intake makes it impossible to fit it in. So Im wondering if anyone else has run into this, and is there a way to...
Saw this auction up and thought it might be worth it for someone closer. Looks pretty crispy but the bumpers may be salvageable.
AUCTION: 1994 TOYOTA LAND CRUISER | CURRENT BID: 25
Like the title says, is anyone running the OEM mud flaps with the Slee dual swing-out rear bumper? I'm wondering if it's even possible to run them if trimmed. Thought I'd check and see if anyone has done this successfully before I start cutting up a perfectly decent set.
If anyone has done...
From searching around it's evident that BIOR/SLEE/KAYMAR/ARB/etc (apologies if I forgot any) all improve departure angle over stock bumper, as expected, but what numbers are you guys actually achieving? I'm trying to figure out what bumper+lift with 33's and without a hitch is best to hopefully...
This last weekend a few friends and I did a little drive up here in Alaska. We went a took what is called the "Bettels snow road" which is only available in the winter. During the summer the only way in is by boat and plane. Then we headed up north and camped just a few miles from Coldfoot...
Anyone ever customize a short bus bumper? I know it is about perfect the way that God made it; however, wondering what people have done to it.
Picked a used one up and thinking about frenching in some round small LED fogs. i would add more structure too.
TRAY - SOLD
DRAWER SIDE KIT 2003 and up -- AVAILABLE
SPRINGS - AVAILABLE
FRIDGE -- AVAILABLE
The tray is the first generation. Got a dual compressor, so am using a different tray that fits the battery and compressor. Selling this for $65. Also have ARB medium load springs. Went to the heavies...
Curious about this one. There's a mount down the lower bumper (big piece) which would allow the spring to flex and bend the antenna back. The higher mount (pictured) doesn't really do much for front-to-back impacts (the typical problem). Any feedback or ideas on this? Probably will put the...
So, I finally scheduled an appt with Slee to install an OME Stock Load 2" Lift Kit. This, with my soon to be installed Falken AT3 (275 70 18) tires, will allow me to tackle a few more challenging Moab trails during our family trip late March. An hour after dropping my rig off I received a call...
After crushing a part of my exhaust off-road I had to cut it off right after the muffler. Didn't notice that the exhaust points almost right at the body side mount of the upper link and now I have no bushing. Slee only sells a complete set of bushings so I'm trying to find a single bushing to...
Sold to a mudder and on its way to a great home.
Most of you will probably recognize this truck, I just bought it off of here two months ago. Envisioned this as a decent truck to load the family up and go to the beach condo in (3.5 hour drive) ... now I think a closer to stock 100 or 200...
Located in Modesto, CA Local pick up only.
-99 e-locker axle, it's missing the brakes but is complete.
-99 e-locked third member which has been removed for above axle.
-Slee, e-locker control box: Slee - Electrical Switches
-Factory e-locker dial for Rear and Front Locker
-Extra passenger side...
As title states... 1.5" front coil spacers made from billet aluminum from Slee.. These were used in their 5" first gen lift approx 10-15 yes ago... Bolts up to spring upper tower...100 bucks plus shipping
Hi, I removed my spare tire swing out on my slee bumper.... Easier for city use (twin babies, wife, etc)....
What can I use to cover the post that the swing out mounts on?
Do not want it getting rusted etc...
Thoughts?
Anyone know if this fits on the Slee rear bumper? Obviously drilling the 100 series bolt pattern would be a given. Anyone tried this?
TITAN TRAIL TREKKER Liquid Transfer Tank for Jeep Wrangler (4040187) -