ignition wiring

Wiring up a Compustar CM-X system for keyless entry and remote start, but running into issues with the ignition wiring on my '93 JDM. Wiring colors for US market are 12V Battery: Black, Starter: Black/White, Ignition 1: Black/Yellow, Ignition 2: Black/Green, Accessory: Blue/Red No factory...

I've got a 1990 FJ62. Had it for about 8 years and the whole time it's suffered from sporadic ignition issues. I had a brand new starter put in thinking that was the issue but [spoiler alert] it was not. Every now and then, I go to turn the key and I hear a little "click" but the starter motor...

Just posted up a hard start thread, and got lots of the regular advice, check cables/grounds, fusible links, solenoid tests, ignition switch etc. But have noticed this typically happens when the first cold comes. Which made me wonder, how does the FJ60 know when the heater is on? 83 FJ60 4spd...

Hey guys, looking for any insight on wiring an ez wire harness to my existing steering column. I have listed what I have below currently. I'm not much of a wiring guru but have made it to this point and I'm eager to get the rig fired up and not ON FIRE. EZ wire -ignition switch start...

Hey everyone, I need some wiring help. Although this is a pig-specific issue, I figured I'd post here instead of the FJ55 section due to the increased site traffic as well as it being a similar issue with FJ40's. Here's the haps: as part of my engine swap on my 1974 FJ55 (1F to 2F) I'm also...

Hello All, Bought my Grandpa's 1976 1/2 FJ40 last year after he passed away. Finally saved enough money to do a little tune up. I'm looking for a few pictures to make sure the wiring to the starter and igniter are correct. There are a few wires in near each competent mentioned just left loose...

I have an unfamiliarly new Starter Motor that looks a bit different than the old one and unfortunately does not have any labels on it that I can see. So my question is simply, Where does the IGN START wire connect to my specific starter solenoid? This wire.... Where does it connect to this...

What's up guys! I'm gonna get straight to the point in this post! Goal: Complete the ignition wiring circuit so that I can start the motor. Dilemma: Diagrams don't look the same. Need to decide which one to go with and need to find where the ign switch start wire (purple wire) goes on the...