front diff

  1. ZRotheohv

    Leaking New Front Diff

    I JUST got my truck back on the road after replacing the front differential, and installed the third with a dry gasket. Apparently that wasn't enough since it's dripping out of there (the bottom is wet and leaves a little half dollar sized puddle whenever I stop). I read about using FIPG instead...
  2. Cruiser Justin

    Wanted  Front diff side gear

    Looking for at least one or two front diff side gears for a 91-97 fj80 also 89-95 4Runner and 90-95 p-up. Any of those will work. Any help guys would be greatly appreciated. Thanks Justin
  3. R

    SOS front diff in pieces

    So a few weeks ago I decided to pull my front differential on my 98 land cruiser and replace it with all new everything including an arb air locker. Well my friend was helping me and he just told me to tear it down and we forgot to mark anything. I bought an air locker, nitro ring and pinion...
  4. cc93cruiser

    Wanted  4 Pinion 00-02 100 series Front Diff

    Looking to buy a 100 series front diff from a 00-02.. Looking to upgrade my 99 100 series from a 2 pinion to 4 pinion front diff.. Thanks
  5. S

    1999 100 Series Front Diff Removal Instructions

    Yes folks it's another thread on a broken front 100 series diff! I just broke mine yesterday afternoon during some (mild) wheeling. Knew I needed to install a locker at some point but just wasn't ready for it yet....guess now I am! So as I searched I found plenty of posts about folks trying to...
  6. R

    front diff ring and pinion

    so I'm rebuilding my front differential on my 98 lc and i bought an arb air locker so i wanna replace the ring and pinion too. I'm keeping the gear ratio the same but i can't find any aftermarket ring and pinions with that gear ratio and all the oem ones are discontinued. where on earth am i...
  7. Surf n Turf

    Seem to have alot of play in front diff ? Troubleshooting

    Hey all, so thing's i must mention is that when i got from Reverse to Drive and on and off the gas there is quite a noticeable clunk noise, had a play with the front driveshaft and it appears as though there is a fair bit of play within the front diff. Have a video i can hopefully upload of the...
  8. SimplyTanner

    R&P swap from ADD to non ADD

    Does anyone know if the ring and pinion from a non ADD diff is the same for and ADD diff? It seems the only difference is the needle bearings in the ADD. Which I believe is actually part of the carrier and the housings are identical. Any help is greatly appreciated, thanks.
Back
Top Bottom