fj60

Hello, Posted in workshops as well, but the truck forums get much more traffic. Just as the title says - I'm designing a garage, and I finally get to put in a lift. Going 2-post as space is a consideration, and most of my work will be wheel rotation, brakes, etc. - need the wheels accessible...

Hello, Just as the title says - I'm designing a garage, and I finally get to put in a lift. Going 2-post as space is a consideration, and most of my work will be wheel rotation, brakes, etc. - need the wheels accessible. The cruiser is the tallest car I own. Others are an 89 911 and an 03...

I’m trying to wire an aftermarket radio, these wires were right behind the receiver slot. The left two wires are showing 11-14 volts on a multimeter regardless of key in on position. I want to wire the receiver to constant and switched power. Will if have to fuse tap for switched power? Or what...

Hi all, First post! I've been slowly working back to life an '83 FJ60 and loving every [most every] minute of the process. Attached is a photo of corrosion on the driver side wheel well and quarter panel. This is the worst of the two sides and appears to be the biggest body issue I am dealing...

Like the title says, I’m looking for a rebuilt (would love a redhead) steering box for my 1984 FJ60. I have the square pattern to confirm. Thank you!

got a steering box here off a FJ62 that didn't leak but was oddly kind of too tight of steering? Not sure what the deal is with it but we put an 80 box on. $100 plus shipping. No pitman arm but can include either 60 or 80 version with nut and washer for $30 additional if needed

https://mobile.craigslist.org/cto/d/theodore-fj60-toyota-land-cruiser/7714431035.html No affiliation.

I adjusted the valves to spec and timed it with the light gun at idle (many thanks to responses to my questions on how to get this far). Previous owner had done a "partial desmog" according to people who saw pictures. Now that the rebuild is done I want to know where I need to run vac tubes to...

NO Longer available

$20 plus shipping cost. Pulled from my 1987 FJ60. These have a little surface rust, but they are in working condition! I bought new ones, so these have to go. I’ll include new adjusting springs. You will need screws for the silver ring trim, though.

Hi All, I am in need of (1) stock FJ60 wheel if anyone has one laying around. Turns out one of them on my truck is bent. Would anyone have one available? I am in Illinois 60901. Thank you

Asking about half of new, $600. Done by a local reputable shop where @Wadesters takes his restoration level tanks to get refinished. I can assist with delivery throughout the southeast.

Title says it all. I wouldn't have saved it if it didn't function properly. Price $50 buyer pays shipping. Best to email me shmukter@pa.metrocast.net

Very nice extra set of snake blinders. $500 plus shipping.

If anyone has a Fog Light switch in good shape please let me know!

Hi all, I am looking to see if any of you have swapped the fj62 gauge cluster into a fj60? From first glance holding the fj62 cluster in hand, the main difference is the Parking brake light is in the cluster and not on the dash. Im wondering if the pin outs are similar between the two, but im...

Gray carpet for the back of the rear seat. Thanks guys

Used H42 for sale out of my 1985 FJ60. I think it had roughly 180k on it when i took it out and it shifted fine then. Prefer not to ship. $250?

I need a pair of steering arms for fj60. Thank you.

Good Afternoon, Everyone, Is there anyone who could share a picture of the correct connections between the igniter and ignition coil on an FJ 60? Thank you! -David