bars

Looking for a set of LC torsion bars or comparable aftermarket set that will fit my 01 LX. Prefer SoCal for local pick up but willing to pay for shipping if price is right. Thanks

Looking for a cheap set of used torsion bars. LMK what you have.

Hoping someone could answer this for me....I have a 14' enclosed trailer and I would love to install at least a 12" led light bar on the back. I already have a small light with switch and I am assuming it's just a 12 volt connection. Can I just remove the old incandescent light and install the...

If you have any laying around from your OME upgrade, please let me know! Thanks, David

looking for all the jack hardware handles and the big bar for cranking over the engine PM me ? Thanks I do have the Jack ! Update only looking for the jack crank bar , I found all the others

I have two grab bars: 1) Brown FJ60 bar, complete with mounting gaskets/pads and screws. $100 2)Grey FJ80 (early years, pre95), complete with washers. $70

I swapped out the AHC suspension on my LX for an OME setup. I have the coils, torsion bars and AHC reservoir. $200 obo - make an offer for local pick up in the Richmond VA area. Thanks

Looking for torsion bars from a 100 series Land Cruiser. Please PM me if you have a set. Located in 20653. Thanks.

Ok, I searched........Still not sure what route I wanna go... I really don't care for a lift on my 1999 100 series. But I am starting to think that after some weight added to the front, I need stiffer springs and don't want to mess with cranking the oem bars.. I have a arb front bumper and I...

Hi, Today I´ve notice that were to mount the torsion bar on the axle not are 90degre. Im doing a RHD/LHD conversion and I have to fabricate a new attachment on the other side but I want to make sure that I´m doing it right. Does anyone know ?

I have searched High and low online and cant seem to find any cheap nerf bars/steps. Now I have realized that the consensus here is to get sliders. I like the sliders but they are a bit pricey right now. I just purchased my 1996 LC and I have a lot of work to do on it, but in the mean time I...

What is the consensus about using or not using the factory sway bar. I have heard some say lose it and others say its unsafe and use quick disconnects for sway bar when off road. I am running the 2-3in lift from toytec with bilstein 5100s and eibach springs. Does anyone out there have...

Manik Side Steps for FJ80/80-series For Sale Reason for Sale: I replaced them with rock sliders Condition: Fair - could use some TLC (pun intended). The bars are structurally sound. Needs a wipe down, maybe rust remover in some spots (How to Remove Rust from Metal), maybe a coat of spray paint...

Manik Side Steps for FJ80/80-series For Sale Reason for Sale: I replaced them with rock sliders Condition: Fair - could use some TLC (pun intended). The bars are structurally sound. Needs a wipe down, maybe rust remover in some spots (How to Remove Rust from Metal), maybe a coat of spray paint...