80 series

Looking for a clean 1991-1994 80 series OEM front bumper. Preferably local to MN. Thanks

About a year old, maybe about 500 road miles and 3 or 4 trail rides. For some reason I cant find my receipt, but Im 99.9% sure its a trail gear kit. Pulled it off yesterday as Im going with a heim set up. Some minor scuffs/scratches. Frame side bracket NOT included. Will ship, buyer pays the...

Looking for the slee short bus for an 80. Thanks

Right, I have a LHD Turbo diesel 5 speed with dual factory battery set up. The positive lead on the starting battery (left side when facing truck) is very frazzled and it's not providing a solid connection. I removed the terminal end to replace it and straighten out the braid so that slides...

tle: Project Overland Beast - Building the Toughest FZJ80 for Australian Touring Hey 4WD enthusiasts! I'm thrilled to be part of this community as I embark on a journey to transform my 1994 FZJ80 Toyota Land Cruiser into the ultimate touring machine. i had unfortunate experience with my last...

This is my first post after using this forum as an invaluable resource over the years. Sadly it also marks the termination of my land cruiser ownership for the time being. My 1996 80 series recently lost an argument with a tree, and I am in the process of totaling it out with the insurance...

My CDL actuator is fried. Does anyone know someone who can rebuild these windings? OR... Does anyone happen to have this actuator?

Replaced my seats with Corbeau seats and Brackets. Thus left with the original driver seats (sans belt latch - needed for my new seats) and looking to sell. Leather is recommended to be replaced. These are the original gray. Pick up only.

have the four original Springs from my 1994 80 (159k miles at removal). I have held onto them for no reason. Looking to sell to someone in need of these. Looking for pick-up. Not sure where to start with shipping these and buyer would pay for shipment and the supplies to do so.

Hi Folks - Anyone here willing to part with their OG Speski barrier? Will pay good $$ PM me if you have one available! Brett

Hi Folks - Anyone here willing to part with their OG Speski barrier? Will pay good $$ PM me if you have one available! Brett

This is a good gas tank other than the dent you see in the photos. I ran it this way a couple years with no . It was removed because the 80 it was in sustained A pillar damage which I decided not to try and repair. I don’t want to ship it. My location is Battle Ground, WA. Come and get...

Not sure what side this backing plate came from, but it's in good enough shape that I saved it. New ones aren't cheap. Check the photo and see if you can use it. $20 plus the ride. Best to email me shmukter@pa.metrocast.net

SOLD! Bought from Kurt a few years ago. Comes with Koyo wheel brearings. $180 shipped anywhere in lower 48. PM me with an offer if you are so inclined.

FOR SALE PARTOUT Pulled Engine and Trans from a 1997 FZJ80 40 yr Ann with 190,000ish miles on them. The truck drove fine in the months I drove it daily but needed work. -This part you can skip. Just a "why'' to parting out.- upon finding out that I needed to redo the HG and timing guide...

I’ve been looking for an original pressing of the 40/60 Series Chassis & Body Manual and found somebody selling a Toyota reprint. He had a whole bunch of manuals and wouldn’t break up the lot. I don’t need these other ones, so on the block they go. All are in almost perfect condition, except as...

I swore id never get rid of these........ hands down the best setup for an 80 series. Progressive and plush and perfect for any uncut 80 series wanting to run 35s. I ran 37s and 39s with these with chopped fenderwells. Whats included. v2 Springs front and rear. Bilsteins valved by...

smoking a tad. bubbles in the coolant overflow. but starts and idles well so i luckily caught it before anything occurred. I have no time to do a HG. I think i have a Toyota OEM gasket set for the job. And ARP head studs new. and possibly the witch hunter injectors- i also have an OEM...

Brand new - still wrapped. Full aluminum skids for an 80 series. Bought them but then my 80 went down in need of major repair and so selling at a loss to help fund the repair. More details in the pics. $480 takes em Local pickup for cash preferred.

Hey Arkansas Folks, I'll save the long story about the squeaking/leaking. Does anyone know a good glass person that has experience with 80 series windshield gaskets? I'm located in Central AR. Thanks, Sam