Started my Metal-Tech stinger

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

treerootCO

treerootCO

Where are my keys?!
Joined
Jun 2, 2004
Threads
157
Messages
3,689
Location
Wheat Ridge CO
Website
home.comcast.net
Started my Metal-Tech stinger and sliders

If I show up to CM07 without the new parts Mark gave me awhile back I might not be allowed in his camp:doh:

Even though it may affect my approach angle a little bit, I decided to set the stinger at 45 degrees. The supports from the stinger to the radiator hoop are parallel with the ground.
DSCF1132.webp
DSCF1135.webp
DSCF1141.webp
 
Last edited:
I wanted the hoop to weld to the top and the side of the frame rail bracket so I relaxed the bend about an inch. When I was trying to eyeball the cut for the the sides I discovered the wonderful world of lazers. :)
DSCF1130.webp
DSCF1125.webp
DSCF1126.webp
 
dude loves the laser



















stop humping the laser mini me

nice job, now you can join the ranks
post stinger done 2.webp
 
Treeroot: Definitely post some pics of the MT sliders. Especially from the underside...I've got a 6/79 and trying to figure out what to do with the exhaust if I run sliders.
 
Mike-

Looks GREAT! Didn't you get a rear carrier from Mark as well?

Are you still blowing smoke, or do you have a fresh motor in there? I musta' missed something.

Your rig continues to inspire!

Drew
 
i'm diggin the slidders......
 
REZARF said:
Mike-

Are you still blowing smoke, or do you have a fresh motor in there? I musta' missed something.
Click to expand...

hhahahaha...you aint missed squat...he's still got the same tired motor. got a better project. got his dad into cruisers, so they gotta build him a motor first :grinpimp:
 
awesome sliders. How long did it take you to fab up?
 
Mark might bring me a rear bumper to Cruise Moab

Same tired motor running on straight 50 weight.

LT did all the fabwork. All I had to do is make the tubes to the frame. It took about 4 hours over the corse of two days.

the lines were made by AAI but they could be better. If they had the right fitting they can go straight back under the bib.
 
Last edited:
You must log in or register to reply here.

Similar threads

woytovich
Builds Metal tech Family cage frame tie-ins
Replies
15
Views
1K
MOTOV8R
MOTOV8R
Water7
FJ40 Metal tubs
Replies
2
Views
1K
peesalot
P
Wadesters
Is an OEM softop possible with a metal tech cage
Replies
14
Views
1K
Wadesters
Wadesters
Rochfort
Replace original metal
Replies
2
Views
724
MOTOV8R
MOTOV8R

Users who are viewing this thread

Total: 1 (members: 0, guests: 1)

Share this page

Back
Top Bottom