Was looking for the sliders for my LC 200. Narrowed down to white knuckle and budbuilt as my top two choices. Decided to go with budbuilt since no drilling required, they state they use American steel, not imported one, and their sliders look very similar to the ones built in Australia for...
anyone has these on their rig? Front Skid Plate | 200 Series Land Cruiser (08-21) - Victory 4x4 - https://www.victory4x4.com/product/V200SD-GN.html
thinking about getting them...
Ok, so I have decided to proceed with front bumper cover removal. Only bumper cover needs to be removed. Few tips, if you have side fenders like myself you don’t need to remove them just remove bolts closer to front bumper and loosen the front bumper. Don’t remove front bumper cover, in my case...
It’s a regular 5.7 gas. Well, the same engineers make you take front bumper, grill and air cooler to access that one bolt which is pure Toyota greed over legacy. Why not just place those 4 bolts on the other side especially for supposedly off-road vehicle:)
Well that hole is right behind the cooler, the only way to not remove cooler and front bumper id to leave passenger side radiator mounting bracket in place? Any thoughts if that would be ok?
Well, my 2009 LC has •AT air cooler completely blocking lower passenger side radiator bolt, looks I do have to remove grille and possibly front bumper😩any ideas?
This area is wet and when slightly push it seems to have dark/gray residue, fluid…I believe bad radiator can have an affect on at fluid changing from red to dark…am I missing something? If I am to replace those hoses for POM do I need to drain any fluid?