Recent content by tyama

  1. tyama

    1972 ‘Mongrel’ FJ40 build retrospective - A quarter century of ownership

    Hopefully, toyota trails will keep doing bios of all the folks who ran shops for 'cruisers and parts guys like CDan, who really helped out folks! their stories need to be told! best ty 🍻
  2. tyama

    Help Needed Valuing 1976 FJ55

    Another vote for farm or hunting vehicle or off road beast build. If the frame is good and the rust is just the panels, someone with a welder could get it going and fix it as they went. The top half looks nice and the engine compartment doesn't look too bad. if the engine fire up and has good...
  3. tyama

    Rear axle bearings

    Those freaking bearing are such a PITA. I hammered them out with a broomstick from the opposite side as I was concerned about scoring the inner axle housing if i used steel pipe. the above older thread is a good resource...definitely a case of "if it ain't broke, don't fix it". best, ty 🍻
  4. tyama

    ‘69 Time Capsule

    There's a lot of great ideas posted so far. however, looking at the pristine condition of the vehicle, I would hesitate to do anything that would remove it from OEM. I know that the safety upgrades: disk brakes, dual brake MC, etc... are important, but your 40 could be a rare OEM driver that...
  5. tyama

    ‘69 Time Capsule

    Nice! beautiful rig! really clean and a nice touch to see the tires off the ground. I bet most everything is in pretty good shape from the way it was stored. I had an opportunity at one like that, a 73', IIRC, but passed it up as couldn't come up with the $10K or so it was going for. The one...
  6. tyama

    Door Stop Limiter Bracket options??

    My tabs on the door were cut off so i did a quick and dirty fix by drilling a small hole where the tabs were on the door and attaching a small section of black 1" tubular webbing with a sheet metal screw and ran the other end thru the body hole with a knot. still works after 16 years. :beer: ty
  7. tyama

    1970 fj40 Rear disk brake conversion Q's

    Thanks! from what I can see, it looks like everything is on as should be. I figured the caliper pad would adjust when the brake is applied. However, i just think the outer pad is too tight and i should take the spacers out. I did the warn full floater plus disk conversion years ago on the...
  8. tyama

    1970 fj40 Rear disk brake conversion Q's

    Hiya, I'm finishing up a rear disk conversion with a kit I bought years ago from Poser. Putting it all together, i find the outside brake pad is really tight on the rotor. It take a good amount of effort to turn the rotor by hand. As I look at the bracket, i see there's a gap on the caliper...
  9. tyama

    Dual Battery Solenoid

    Hi, I have the same setup in my pig. Here's where you can get replacement parts: https://dirtyparts.com/store/detail.cfm/RELAY---SOLENOID-200A-SEALED/pid-114422 best, ty :beer:
  10. tyama

    Any decent Fj40 alternator replacement options out there? (internal voltage regulator)

    Hi, I've done both. I run the fj60 60 amp on the fj40 and the gm one wire on the pig. both work well. the fj60 was a drop in with the wiring kit from coolerman (great vendor to work with, BTW). the GM one wire (CS144) required a wire to the pos term with a fuse. IIRC, I had to make sure the...
  11. tyama

    Headlight Bucket Rebuild Threads?

    hiya, i think most people just retro fit with the closed buckets as outlined here by wngrog : https://forum.ih8mud.com/threads/fj40-head-light-upgrade-led-bulbs.1173612/page-6#post-14962798
  12. tyama

    1970 in CT

    great thread! hope it goes well and you get done soon. :beer:
  13. tyama

    Build New project, 1969 fj40

    Great write up and journey! always fun to read the work on bringing old cruisers back to life (esp the early ones!), and the neat ways folks work through their hiccups. thanks for the updates! :beer: ty
  14. tyama

    Post Pictures of factory AC.

    HI, what manual is this one from? I've got a '79 with the AC, mostly pulled, & i thought i had the last body manual for it before the '60's came out. i'd be interested in seeing what other manuals are out there for late model pigs. thanks, ty
Back
Top Bottom