Recent content by TLEXAS

Marvellous work. Please provide an expose' on the screen you have mounted. The trouble with us that lurk on these IH8MUD pages are like magpies and see some new shiny improved modification that we would also like on our own rig.

The 6 piston Power Brake kit for the front looks good but would also need to fit say a four piston rear the same to maintain a relative balance across the system

Any record of part numbers and recommendations for a supplier of the Stoptech Big Brake kit. Have experienced a few brake fade events over the past couple of years so am keen on replacing my calipers so may as well upgrade

The getting out and changing 2WD or 4WD was only a minor issue. The rear concern was when rear end got loose a couple of times （unplanned on my part） on wet and gravel roads and I wanted the reassurance of fulltime 4WD that I was used to since buying the rig brand new. The supposed fuel saving...

Am over my part time kit. It was a work around when internals of transfer case exploded earlier this year. The last clunk in the clunk reduction journey that many of us get on. Have sourced a new transfer case out of Toyota for $1400 NZD about 800USD and will go back to full time 4WD. Can drive...

Has anyone got access to Toyota FAST and can they run 48161-60100 & 48162-60100 and 48161-60120 & 48162-60120 to determine part applicability for different models of our 100 series. The OEM part for us diesels with AHC 48162-60020 (1210mm x 25.5mm) is no longer available but apparently the part...

Am keen on 1210 27mm for my AHC equipped diesel

https://www.domi-works.com/products/toyota-1fz-fe-to-dodge-8hp-70-75-90-95-hellcat-scat-pack-trackhawk-adapter-kit

What a massive amount of effort to date. Looking forward to seeing product available sometime soon. Once you have sorted out the 80 series products please review what you might be able to offer us 100 series folks. My current go-faster mods require me to circle back to also require me upgrading...

Good morning Patch Am keen on the diesel version (1210mm) AHC version torsion bar set in 27mm when it is available. At 630,000km and with an ARB safari bar my OEM torsion bars are getting a little tired. OEM bar which are 25mm are no longer available from Toyota or other suppliers such as...

Hi Snowman Am suffering a similar wind noise issue in the top corner of my drivers door. I have two layers of sound insulation throughout my Landcruiser a butyl layer and mass loaded vinyl. I am now tracking down one of the next level of sound annoyances one of which I note others have resolved...

https://performancedieselintercoolers.com.au/product/pdi-transfer-torsen-for-full-time-transfer-case/

I will need to check out the details but I believe my transfer case on my 100 series is the same as what runs on your 80 series as I also currently run the a442f 4 speed. Its fitted with a Marks p/t kit and was supplied and installed by Trundles. I can put it aside for you once I go back to...

If you ever venture down into the Waikato give us a heads up as keen to compare notes in person. I have some further preparatory work before doing my conversion and am finding the tips provided by others very helpful. Need to convert back to full time 4WD as well. When I was last on the dyno...

Thanks for your offer of assistance. Am still in the process of accumulating gear and the funds to commission the swap. Are you able to share some photos? Also keen to know the following. What system are you running the auto with? Turbo Lamik or something else? I have a Boostec system. What...