Recent content by Slow85

I have a 1985 fj60 I would be willing to purchase a set and test the fitment I sent over a email as well.

If you utilized 2 Molle panels to support say a Milwaukee pack out. How muck weight would it support?

I’m looking at ordering a set of these now, there is not a lot of storage behind the passenger side panels. I would personally like to use 2 Molly panels on the right passenger side and then keep the doors for access on the left driver. Maybe offer them in a 2 pack? I still would like to have...

Selling my 1968 Fj40 factory soft top, original body and paint. I have the original soft top doors they will need to be refurbished and a set of hard doors. The truck runs and drives amazing I use it as a daily. But is far from perfect has lots of patina and rust! I built it over a few months it...

I’m in need of a replacement front driver door for my 85 Fj60. I do not need the interior just a clean no rust door. I would be willing to purchase a Passenger front door for the right price.

There is a fj40 top in Reno I would like to buy and get transported to Florida or any of the South Eastern states.

Alright so I don’t think I’m low on refrigerant my pressures are 100psi on the low side and 100psi on the high side truck off a/c off. So the system is full. A stuck expansion valve will give you these symptoms. So I have read I have no clue! For some reason it’s not opening causing the low side...

Ok I install everything back into the truck and added 1.5lb of R134A. 85deg outside, A/C gauges hooked up 150 on high 80 on the low. Turn A/C on high and recirculate compressor comes on cold air blowing but quickly cycles back off after 15sec. Low pressure when the A/C come on goes from 80 to...

Expansion valve 475-0101 direct fit no adapter. Evaporator-476-0072 Low pressure switch 88645-30250 Now I have 4 wires that I need to terminate starting in order from the A/C amp plug. PIN 5 - Solid Black. Ignition Coil signal. (input). Where does that terminate? PIN 6 - White/Black stripe...

When I checked it before yes getting everything back in today and tomorrow and will check again.

The expansion valve with adapter is from Rock auto Part# Denso 475-206. And the one I took off had the adapter. Shiny one is the new one.

I ordered a new Low pressure switch from Toyota. Part #88645-30250, I also order a Different Expansion Valve Denso Part# 475-0101 to see if it comes with an adapter or is a direct fit. The Denso one I have has an adapter and I feel like it is running out of threads before it seals. And yesterday...

Has anyone used a 86 and newer Low pressure sensor in a 85 and back. And if so any issues? 80-85 part number that is NLA Well that made my heart sink thank you for that dang! I clipped the bottom side of the resistor I did not remove it completely you have to look closely at the photos.

I swapped my 60 last year and got it finalized this year all except the A/C. I’m not getting power to the compressor! My A/C went out before I parked it for the swap. And I never did diagnose what was wrong before. What I have now is LQ9/Nv4500/split case. Using Holley Terminator X to control...