Recent content by scottmk1

What is this Terrain Tamer airbox seal kit you speak of?

I have them in PDF format if you need any more in future.

Looks great. What is the part number for those rear flaps? I have ones from Superior Engineering but the are starting to curl up towards the tyre

Where is that text from @OGBeno

Yes, it changed in 2007 to accommodate the change to the V8 engine. It's approximately 100mm wider at the front

I think I asked both companies, but will ask Cruiser Consoles again and see what the answer is.

I'll have to ask them again

I was going to buy one, but they told me they don't ship internationally?

They are so much comfier than the factory seats too, granted the drivers side one had seen better days

Fitted a pair of Recaro Expert M's to replace the factory seats, nice space between the seats now to fit some sort of storage box.

Got the factory flares fitted & painted body colour (not my handiwork unfortunately) to replace the Kutsnake ones.. I'm glad I done it now, looks much better to my eyes,

You would be looking at the following: Rear axle housing, possibly brake backing plates if these are different to non ABS Front steering knuckles ABS pump Wiring harness, which I guess will be a complete vehicle replacement Wheel speed/ABS sensors Tone rings for these sensors - is it possible...

I don't think so, my 79 doesn't have ABS. I guess retro fitting a factory ABS system would mean a massive amount of work bearing in mind the non-ABS truck hubs and rear axle wont have any facility to insert sensors etc, plus the wiring looms, ECU, pump, brake lines and dash warning lights.

Is it being imported to the UK?

Installed an electronic transmission park brake, mainly due to the factory setup no longer working very well after doing a rear coil conversion which puts the cable off to the LHS rear wheel and makes it a pain to set up