Recent content by rmckay1021

  1. R

    Seen today near Chattanooga Tn!

    Was out driving my 64 FJ40 and happened upon this FJ45 at a gas and go outside of Chattanooga, Tn. Stopped and stuck up a conversation. Owner showed photos of where he found the truck abandoned in the Arizona desert. Said he took it home and over the years turned it into a driver and built out...
  2. R

    Give me speed

    Switched the stock 4:11s to 3:70s in my 64 street driver and it made it all the difference! So much better!!!
  3. R

    1963 Land Cruiser Complete Rebuild

    @jacktornio, I have a restored 64 FJ40 with a 350 small block and a SM465. They work great in my truck! Go for it!!!! Good luck and will be following!
  4. R

    Where Have you Driven Your 40-Series This Week?

    I believe that my 64FJ has the same roll cage as yours. Do you know who manufactured it? Nice truck!!!!!
  5. R

    Media FJ40 Pics from "Back in the day" (70's, 80's)

    @65swb45, do you happen to recall who made the roll bar shown on your truck? I believe mine is still sporting the same one!
  6. R

    Inside or outside?

    Mine is always in a garage when not doing local driving or traveling in it.
  7. R

    What have you done to your Land Cruiser this week?

    Same problem as you. Just replaced the master and slave cylinders only my 64.
  8. R

    Box under driver's seat?

    A couple of pics showing the tool box still in my 64 FJ 40
  9. R

    Help needed with failed clutch MC

    @sleepycruiser, I will be glad to post pics, but my 64 is not stock. It has a full spring over and an old school SBC conversion. The sheet metal is close.
  10. R

    Help needed with failed clutch MC

    Thanks for your reply. The mc and sc are not stock for a 64. Likely off a 71-75. I found like replacements for both and will stick with them. The truck body is near original but not the drivetrain. Thanks again!
  11. R

    Help needed with failed clutch MC

    Thank you kindly!!!
  12. R

    Help needed with failed clutch MC

    No clutch and leaking down the interior firewall. Believe it is OEM but looks to be from a 75 …. not 64. Thanks!
  13. R

    Help needed with failed clutch MC

    Thanks kindly for the advice. Found mc and sc on internet. Changing both while I am into it.
  14. R

    Help needed with failed clutch MC

    Have failed clutch master cylinder on my 64 fj40. Don’t believe this to be OEM (pic) …. but don’t have the expertise to know for sure. Any help identifying the component, replacement option, or rebuild kit greatly appreciated. Thx!
Back
Top Bottom