Hi Bro,
Quick question, did you solved this? Im facing the same issue with my truck, hard to start, rough idle, from 2k rpm to 3k rpm, you can feel the struggle to pass over, misfire at idle... just like you, my 3fe has been rebuilt almost 2 months ago but since then its facing this troubles. I...
Hi guys,
I had replaced the fan clutch, water pump (both aisin for 3fe) i had installed the fan shroud (brand new from UAE) and replaced the head gasket, and im stilling having problems with the ac when its on and the truck its on traffic. Plus, the truck its running without the thermostat...
Hi guys.
A despite that this its and old thread, im facing a few problems with my 3fe 80 series. When the ac its working, i dont have a raise of the temp, at least its not noticeable, but the fan clutch dont "disengage" and when i turn off the truck, the coolant start to spill out by the...
Another testimony of this afm.
I have installed the cardone 74 20070 a year ago on my 3fe with a set of 6 injectors from 3vz (23250 65020) and runs great. Top speed on highway of 100 mph and average of 80 mph measured with gps, and 33 mud tyres.
Hi guys!
Just a question, i had replaced the injectors, fuel pressure regulator in a 3fe fj80, but the pressure barely reach 10 psi at the rail and 40 psi measured directly from the output of the fuel pump in the tank. I remember that a few months ago, i had measured the fuel pressure from...
After make a search, i found that the 23250 65020 has a flow rate per min of 192 cc, tbe 23250 74060 has a 190 cc p/min and the 23250 61010 has a 208 cc p/min. That means a difference of almost 8% less respective the originals that came witht the 3fes. For my side i think that its fine. Are...
Im interested to know some opinions. Even you will find at least 3 more part numbers. I will give you one. 23250 65020... Its the rpart number for the injectors on the 3VZ 3.0 v6 engine from 4 runners and tacos... Incredibly fits on the 3fe.
Hi bro.
I know that its an old thread. I want to know if this injectors (23250-65020) were working good in your engine before you had pulled out, im looking to replace my 400k injectors because are getting me problems and im looking for this like an option.