Recent content by pkniland

Spent some time at Sand Hills State Forest. Its easy, fun, remote area with a lot of off pavement stuff.

Angus and Crock Pot registered.

Couple of hoses were real close to giving out. That little one under the water pump was blown up like a ballon

IH8HeaterHose. Couldn't get temp up; new thermostat and 90% of the hoses replaced. Was real lucky the housing bolts came out clean. Got temp and no leaks, for now. Cant get the rear heater working but I did get to find out what coolant tastes like. Also did diffs and transfer case fluids.

Anyone got a lead on a, 99332-11250-78, OEM AC belt? Looks like they are NLA

Ill just have to find new help from now on.....😳 JK I got the choke cable routed but I am pretty sure its fouled up inside the house. It looks like it got crimped at some point so it doesn't slide in and out very easy.

Noticed "Chinese" stamped on the fuel filter so I swapped it and fuel line our out with new OEM. Seems to start much easier now, may just be in my head.

Yea, i can bring it along

Only snag we hit was finding a solution for carb studs, but install went well. The previous owner keep all the OEM linkage so that was a huge help. Sourcing some of that stuff is difficult. Have a few people that know these trucks pays huge dividends. I learned a ton in the process.

Huge improvement. The way it drove with the weber seemed like it was only getting half throttle. Its a whole new truck with the new carb

Free to a good home Weber carb off of Angus.

Thanks to @roadstr6, @Cirbo, and @angerhater today. Couldn't have done it without them,

Cant thank @roadstr6, @Cirbo, and @angerhater enough for the help today. The boys helped with the City Racer carb, valve cover, and checked valve tolerances. It feels like a new truck. Jim C air pump pulley, and new corner markers .

We were out of country last weekend so sadly no.