Recent content by notgoodenough

I will definitely check those. Starting with the oil fill cap seal.

Hi Mud, Just got this 2000 LC and took the engine cover off. I already wiped a bit of the grime off of the oil shaft and sides. I am getting ready to do the timing belt and water pump but I have to clean this first! I am guessing that the previous owner must have over filled the oil and had...

Hey @andrewz any chance you have any leftover clamps? I would love to buy a few. Just got the same thing on my lifted 2000. I am in WA, idk how much shipping would be for you to get a few up here. Was shipping really $15 from mcmaster?

Good idea, looks like my local auto zone has a 5 piece set I can pickup. I will do that tomorrow and report back. I have not tried heat, the days here in Seattle are around 45-50. How would I go about heating it? :D Also, for my knowledge, what is the red circled part called, I want to call...

Hey all, Had a half successful half frustrating day today while trying to replace my stock upper control arms with SPC arms. I started on the passenger side, I used a 5 ton puller which wouldn't make the ball joint budge, then I can't tell you how many times I hit the damn ball joint with my...

In regards to TRE Boot, Thanks! I will remove boot and see what is going on in there. I checked my ATF fluid, looks like I have lost only a tiny bit, if any. I was mistaking the sway bar as a tie rod. Now I understand that the tie rod inner and outer are attached, duh. I am going to go look...

Good Morning All! 275K 2000 land cruiser. Just purchased recently, 2 inch lift. I have been adjusting the torsion bars in front to get the ride height correct, 21.5 inches hub to fender on passenger and 21.75 on drivers side (finally got it!). Also was able to successfully adjust the panhard...

I do think that this works for this bar too, but the nuts are in such a bad position located at the end of the bar on each side which means they are usually too tight to the frame to get to (should be located in the center of the beam like on other bars). I think this specific ROKMAN bar is...

stay with me here. I think that the "frame" would be threaded, that way you just have to screw the bolt into the frame since there is no access for there to be a nut. On the passenger side you have access to both sides, nut, bolt and washer. If this is the case, you would ALWAYS want to...

So, currently working on removing my adjustable panhard bar to shorten it to bring the drivers side rear tire toward the center of the vehicle (by about 3/4 inch), (I know im shifting everything by 3/4 inch). I was able to get the bolt out of the passenger side where it links the panhard bar to...

275k, still original. About to replace it and do my Heater Tee's. Is 4G of red coolant really $120?

I like them, they are solid, they have locks on them for security, slide out nicely and fit in the LC very well. No rattle while driving. I am getting rid of them because I want a dual drawer system so that it can be pulled out another 3 feet for cooking. If I don't sell these I would...

If these are still available come November when I am back in the PNW I will come pick them up!

Thanks! Would also trade for some cash plus recovery gear, fishing gear, rooftop tent. If someone local to me wanted to teach me the beginnings of wrenching, could trade this for time in the shop.

Came with recent Land Cruiser I bought. Basically new. Looking to sell it and build my own drawer system. Make me an offer. Located north of Seattle in Everett WA.