Recent content by mpmoody15

  1. mpmoody15

    200 Series Tire and Wheel Size Database

    BFG K03 285/70/17 on Method 703s. Stock suspension. Slight rub at the front during a hard turn in reverse.
  2. mpmoody15

    Let’s see those 200s camping…..

    I spent the weekend up on the Arizona Strip hunting for antelope. The LC mainly had tow duties for the Honda side by side but she did get to run some roads. I ended up sleeping in the back for four nights due to a thunderstorm the night before opening day destroying my tent.
  3. mpmoody15

    SQOD Squad - Stupid Question Of the Day

    I have four Method 703 wheels sitting in my garage just waiting for me to pull the trigger on four 285/70/17s. I'm not sure what my plan is for the spare. I believe the stock size of 285/60/18 will be a little too small to continue using as a spare. Do I purchase another 703 wheel and a fifth...
  4. mpmoody15

    New to me 2008 LC 200, 54k miles, Denver

    Nice. I bought my 2014 with 37k on the clock from the Land Rover dealer in Glenwood Springs two years ago. Same story as yours: it sat in someone's garage most of the time in Colorado.
  5. mpmoody15

    Let’s see those 200s camping…..

    Colorado 2nd season deer hunt. First pic is on Tuesday around 6pm. This is Wednesday at 930am.
  6. mpmoody15

    What have you done to your 200 Series this week?

    One banana job. Worst part was peeling back the plastic under the trim panel, reaching my hand up into the narrow part of door to remove the old door check, then having to reach back in to install the new check. Got that black adhesive all over my arm. I did have a little fuss with reinstalling...
  7. mpmoody15

    What have you done to your 200 Series this week?

    Replaced my driver side door check. Only 55600 miles on my 2014 and it's clicked every single time in my 14 months of ownership. Very satisfying how quiet the door is now! Both pics are the old door check.
  8. mpmoody15

    Gamiviti Dash Accessory Mount Review?

    @Boston Mangler , any feedback so far with the Leather and Dirt offering? The low heat resistance of only 144 degrees gives me some pause as we’ll be there next month in the Phoenix area. I too gave up with trying to make the Gamiviti setup work.
  9. mpmoody15

    Let’s see those 200s camping…..

    Just wrapped up ten days at 10000ft hunting second rifle season for mule deer in Colorado. 6 inches of snow on Saturday followed by -6 degrees on Monday morning. Lots of mud later in the week. Zero issues.
  10. mpmoody15

    SQOD Squad - Stupid Question Of the Day

    I spent several hours over the last few days installing Budbuilt sliders on my 200. For the most part, everything bolted up ok EXCEPT for the KDSS lines and manifold on the driver side frame. Those shifted back by 1/4” and I have no idea why. How important is it that these are bolted to the...
  11. mpmoody15

    Let’s see those 200s camping…..

    Quick weekend for the AZ fall bear opener. Spent 14+ hours each day suffering on the mountain so I didn't bother with an elaborate camp.
  12. mpmoody15

    Gamiviti 200 series products & solutions

    I have the pins bent to 90 degrees. Redid everything again for my third and fourth attempt. Still looking like garbage. This time the back sits proud and the front corners are proud. Gap at the bottom front as seen from outside the vehicle: View from the front: All tabs have been bent to...
  13. mpmoody15

    Gamiviti 200 series products & solutions

    I spent about an hour trying to install the dashboard accessory mount in my ‘14. No matter what I did, the plastic piece did not want to reinstall with the accessory mount attached. I could get the rear plastic tabs to insert back into the dash but the front did not want to. When I started with...
  14. mpmoody15

    The plastic brackets/fins

    I can’t give you part numbers but here is a pic of mine:
Back
Top Bottom