Soldered a bullet connector onto the nut, I'm a little rusty buy it came out alot better than I was expecting. Works great so far, connection feels super solid
Few months back I think I fried my 12v socket with a cheap compressor. Just got it apart today and the only damage I found was where the connector attaches to the back of the housing. Problem is I have no idea what it should look like, can any one identify this connector?
Here's the back of...
I'll throw in another vote for bowfin, the t-channel makes it really easy to modify mounting points as needed. For my camping bins I can interlock the feet on the tube front to back and use a couple pieces of right angle as cleats for side to side then just have to strap it down. I like that it...
Another quick thing if you haven't dug into the driver side rear quarter panel yet, there are plugs in the rear quarters for draining water, pull those and see if it's holding water, ended up having to clean all my rear quarter connectors because they were under water. It's supposed to drain...
I used this kit on my cold start injector, works great. Keep it in my spares kit for road side diagnosis Fuel Pressure Gauge Kit 22RE 3VZ (EFI) - https://www.lceperformance.com/Fuel-Pressure-Gauge-Kit-22RE-3VZ-EFI-p/2019128.htm
Well I thought the ARB bumper was designed specifically for the 8274 but I'm about 1/2" to close. I marked the offset through the original holes
I may have room to put another set of holes in the bumper to increase the space about an inch but would put me real close to the bend. Will dig...
Haven't made much progress on anything but maintenance in awhile on account of the daily losing a timing belt and I ended up having to do a head swap on a modern volvo so that was fun. Recently got a new windsheild installed, the original was pitted so bad night driving was terrible, but it...