Recent content by LaTuFu

  1. LaTuFu

    2000 Toyota Landcruiser car not accelerating properly

    If you don't want to go the techstream route, then invest in an inexpensive OBD Code reader. You'll thank yourself later on. Trucks this old are going to throw codes often enough you'll get your money out of a $50-60 reader.
  2. LaTuFu

    What have you done to your 100 Series this week?

    Check out the thread @Mauser has for Master Key and ECU Reflash. PM him here on the board and he can work out the details with you. Pulling out the ECU and shipping it to him is easy enough to do. The biggest PITA of the whole project is the truck being disabled for the week or so it takes to...
  3. LaTuFu

    What have you done to your 100 Series this week?

    Got the last of two ECUs back from @Mauser to wrap up my new master key project for the 00 and 01. Also got His n Her YotaMD key fobs for the two master keys that will be daily use. Was a mild PITA having one truck or the other disabled for 2(ish) weeks, but it was worth it finally have new...
  4. LaTuFu

    What have you done to your 100 Series this week?

    Replaced coils and plugs with Densos. Previous owner had installed Bosch plugs and aftermarket Coils. I am pretty pumped by the difference in engine response just from this one change. Also swapped fluids in diffs and transfer case, repacked front bearings, replaced front pads and rotors...
  5. LaTuFu

    Trim for aftermarket stereo

    Post a picture of what your current setup looks like. I replaced a single DIN unit in my 2000, it had a little storage tray mounted underneath it. When I put in a Double DIN unit I did not have to get a new trim bezel.
  6. LaTuFu

    Looking for Truck, Is this worth it?

    If all it has is an OME suspension, he's really overstating the value of that truck. '99s with 200-250k can be had all day for less than $10k. Yes, you'll have to be patient, and careful about inspecting the overall condition. But you don't have to overpay for the truck. They're great...
  7. LaTuFu

    Question on selling my LX - with or without add-ons?

    Sell it in the FB 100 group. They routinely list trucks with a lift, aftermarket wheels, a snorkel and a bolt on bumper and want $25-#30k or more. And get offended if you raise an eyebrow. Seriously, though, I think you're better off selling the mods separate like any other project vehicle...
  8. LaTuFu

    Full audio upgrade, speaker sizes?

    As a guy who can struggle to avoid temptation and dive too deep on projects sometimes, I feel your pain. I just recently did this with my '00 non-Nav, so we're pretty much in the same boat wiring-wise. I would encourage you to consider sticking with a double DIN product you like from...
  9. LaTuFu

    Suspension tuning question

    Will definitely check them out, it can't hurt. Hopefully nothing has come loose in less than 8,000 since being replaced.
  10. LaTuFu

    Suspension tuning question

    Front links and bushings are definitely on the list to check out. Rack and bearings should be fine, they both were replaced/repaired within the last 12 months. I'm thinking the control arm bushings are next. When I was doing the shocks and springs the CA bushings were noticeably worn...
  11. LaTuFu

    Suspension tuning question

    No, standard Land Cruiser OEM Springs and Shocks. I did a 4 wheel alignment at my local dealer after installing the suspension.
  12. LaTuFu

    Suspension tuning question

    I have replaced the F&R shocks, springs, and rear sway bar links in our 2000 and 2001 LCs. The 2000 feels pretty solid and the handling is greatly improved. The 2001, on the other hand, still has a lot more body roll to it than I think it should have. The VSC warning will kick on in a turn at...
  13. LaTuFu

    Build The Baba Yaga Build

    I wouldn't worry about the Radiator or hoses. If there are no cracks or signs of dry rot let it go. Use the money for stuff that needs baselining.
  14. LaTuFu

    Build The Baba Yaga Build

    I recently did this project for our 2000 and 2001. I would recommend OEM all the way around like you are planning. New sway bar links and bushings are a good idea. Unless the torsion bars are damaged, I would suggest completing the shocks, springs and sways as one project and then assess from...
  15. LaTuFu

    Would you trust your Cruiser to Best Buy?

    Do not trust big box retailers for installation. Especially for older trucks. They pay minimum wage and training is virtually non-existent. If they screw something up you're more than likely SOL. If it were me, I'd wait until I had a 3 day weekend or a day off and do it myself. Order...
Back
Top Bottom