Suspension tuning question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 18, 2017
Threads
7
Messages
41
Location
Virginia
I have replaced the F&R shocks, springs, and rear sway bar links in our 2000 and 2001 LCs.

The 2000 feels pretty solid and the handling is greatly improved. The 2001, on the other hand, still has a lot more body roll to it than I think it should have. The VSC warning will kick on in a turn at speeds of 25-35 mph. The 2000 can go through the same turns at the same speeds and no VSC warnings. The truck feels more stable in those turns, too.

Any suggestions on additional items I should consider checking out?
 
I have replaced the F&R shocks, springs, and rear sway bar links in our 2000 and 2001 LCs.

The 2000 feels pretty solid and the handling is greatly improved. The 2001, on the other hand, still has a lot more body roll to it than I think it should have. The VSC warning will kick on in a turn at speeds of 25-35 mph. The 2000 can go through the same turns at the same speeds and no VSC warnings. The truck feels more stable in those turns, too.

Any suggestions on additional items I should consider checking out?

DO you have AHC?

For me it was alignment.
 
No, standard Land Cruiser OEM Springs and Shocks. I did a 4 wheel alignment at my local dealer after installing the suspension.
 
Check your control arm bushings in both the front and rear. They could be worn out.
 
Also check front links & bushings, steering rack and wheel bearing for play/wear.
 
Also check front links & bushings, steering rack and wheel bearing for play/wear.

Front links and bushings are definitely on the list to check out.

Rack and bearings should be fine, they both were replaced/repaired within the last 12 months.

I'm thinking the control arm bushings are next. When I was doing the shocks and springs the CA bushings were noticeably worn, cracked and dry rotted.
 
Front links and bushings are definitely on the list to check out.

Rack and bearings should be fine, they both were replaced/repaired within the last 12 months.

I'm thinking the control arm bushings are next. When I was doing the shocks and springs the CA bushings were noticeably worn, cracked and dry rotted.
I'd not assume "should be fine"! Loose wheel bearings are a leading cause of setting off VSC in turns.
 
I'd not assume "should be fine"! Loose wheel bearings are a leading cause of setting off VSC in turns.

Will definitely check them out, it can't hurt. Hopefully nothing has come loose in less than 8,000 since being replaced.
 
Back
Top Bottom