Recent content by Landshark

No worries, I ordered an aftermarket but made in Japan water pump from Raddcruisers in Kamloops, only problem is I live in Sorrento which is right near the big Adams Lk fire (44,000 ha) and our post office is closed.

Thanks, I forgot about Radd Cruisers in Kamloops, just down the road from where I live near Chase. I don't think he operates out of a brick and mortar store, online via mail only but still close. His web site is very user friendly and shows part available but aftermarket but still made in Japan.

Thanks, I live near Salmon Arm and went to Lordco in Salmon Arm and they did order an AISIN WPT-023, but not the correct one. It was $275 after taxes so I think your looking at the same one. I want to give a shout out to Derry who works for Lordco, he has worked for Toyota and was a great help...

I have tried most local auto suppliers, Lordco, Gilberts etc and no luck. Toyota wants $330 and it will take 4-6 weeks. I have tried 4Wheelauto in Edmonton as they have one on their web page but waiting for them to get back to me. I wanted AISIN or other OEM but will now consider other...

Yep, happened to me. #6 cylinder pre cup dropped after only 50k, injectors done as well. Was going for rebuild but found a 2h with 300k so did engine swap my self. Cost was $1k for donor truck and 500 for misc parts and some help. Sorry to hear, it is so heartbreaking to have major engine...

Hey, I just bought the G7200 at CT and not yet home with it to test hook up in 24 volt mode but I don't think the cable clamps will reach my high side positive and low side negative battery posts. Looks like they will be 1 foot too short. How do other get around this problem? I too want to...

I have had the Solar in my truck for about 15 years, it has not been driven for the past 6 years. I now have it going again and I am trying to put new fuses in the Solar but when I connect the wires, the 15AMP blows. I hook them up black, red, white but the 15 amp blows right away. The...

1. 1987 Canadian HJ60 2. Landshark (Bob) 3. Noname 4. 575,000 kms (225 kms on replacement engine) 5. Modifications; Belton 2.5 inch lift, reinstalled stock am/fm pushbutton radio. 6. Special expedition trips, plan to instal ARB front bumper and 33 inch tires. (trips to recycling and dump are...

Sorry if this has been discussed before, I could not find info I need using search. Anyways, I have a 1987 HJ 60 Canadian model that I only drive during the spring to fall and even then I may go weeks without driving it. I have a Solar in equalizing mode but even then I find my batteries may...

Wow, great restore of a HJ60. I live in BC Canada and have a 1987 HJ60 as well. Since you have your dash apart, can you see if you have the original stock car AM/FM stereo connector? I am restoring my HJ60 as well for Collector Plates and need to reinstall the stock radio to apply. Looking...

Hi Tin B, I live in Prince Rupert. But I will be coming through the lower mainland mid May. Send me a pic of your bumper when you can. Also really need the sub cross frame as you can see mine in the picture is toast. I was going to remove it and get it welded up if I cannot get one from...

Removing rear bumper update. So I found out I could remove the chrome bumper without removing the hitch and also I did not need to remove those 2 middle chrome carriage bolts. There was a black mount that was bolted to the inner rear cross frame, so I just had to remove 2 bolts. I had no...

Actually looks not bad. The gaps in the doors back from the front fender look ok. Just get used fender & hood, put a custom/home built bumper on and body wise you are in good shape. The electrical just needs to checked to find where the problem is, (I know it sound like Capt. Obvious) but it...

Great tip on the clamping of the top of the carriage bolt head. The hitch is not in the way. The two bolts on each end I can access the nuts underneath, it is the two bolt nuts in the middle shown in the picture, the inner "C" channel is in the way to fit a socket. I think I can fit a...

I removed my rear bumper once but that was about 15 years ago, I remember taking it to a garage and asked them to remove the two middle top bolts. They just ground it off making scratches to the chrome. So I want to do it myself. They been soaking in penetrating oil for the past week. I...