The two pieces MUST be done AS ASSEMBLED if you want it to seal. The exhaust horns will need to be fixtured to prevent twisting - again - if you want it to seal.
You will likely need to shop around as machinists are not made from the same cloth as they once were. The good guys got too old to...
You wouldn’t happen to have the turnbuckle assembly that connects the under dash e brake linkage to the bell crank on the engine side of the firewall for an fj55, would you?
Hey sty. I’m trying to put my dash pull e brake bake together, and need the turnbuckle assembly that connects the under dash linkage to the bell crank on the engine side of the firewall. I’ll also need the clevis pins, and boot. Shipping to Fresno, CA. TIA!
if it only does this after warm, check the vacuum lines from the BVSVs on the stat housing. They only open after a certain temp, and leaks downstream wouldn't be noticed till after warm.
Pigheads cruiser was birthed prior to the existance of heat shields...
Carb rebuild mostly implies a deep cleaning that gets all the junk gas varnish out of all the tiny passageways that get clogged by junk gas varnish. Barring linkages or shaft bushings , you should be able to do this till the...
I could never get my weber to not run rich... definately look at your ignition. Does it have OEM ignition, or HEI. How is you tank vented? Have you checked for vacuum leaks?
Thanks guys! The stitches definitely were the worst part. Had to go thru the nail. I’m a big ol baby. Glad that’s over. Seems like it’s gunna be ok… someday soon I hope. I’m useless left handed.