Recent content by jsigone

I put in a denso unit from Partsgeek last year., $220ish shipped including $40 core fee Also got the lil module for cheap to throw in spare parts bin for when camping in the desert. https://www.partsgeek.com/1x72ntv-toyota-land-cruiser-alternator.html Here's the brush kit to reqbuild your old...

If you a have a calliper to measure, Non-ACH TBs are 28.87mm, which is about 1.1 inches, while the ACH TBs are 25.5 mm, After market bars are 30-32mm. Sway away are 32mm, I run those. I think ARB are 30mm.

sounds like good bone for project car. Seems like you have a valet key only. So you can pay 3-500 for two master keys from dealer or there are some threads on here to use Techstream and program some ebay keys. I'd prioirtize this as ECU has built in immobilizer, so you don't want to get stuck...

good rig for start point. Leaking oil is likely from Valve cover gasket w high chance of those bolts just loose from heat, like hand tight loose. I did the gasket since I was that far in already and had the part plus didn't want to do the work twice. Red fluid is likely power steering, these...

latest iteration... since the RAAM mount kept failing on me. FANAUE Phone Holder Aluminum Alloy with ball mount and extra threaded holes on backside ctr or bottom flange https://a.co/d/bxqBmbQ pair to Delkin Devices Fat Gecko Mini Suction Camera Mount https://a.co/d/aAD8UxM I double sided...

@sexilexi470 Method Racing "Roost" 18x9 +18

San Diego sunset

If you didn't swap them last, then time to baseline them and be safe. It's like $25 maybe some coolant.

you can either get a 5 channel amp or ditch the sub idea (save money) and run new speakers off the alpine head unit. It should power 50w per channel pending model and modern Ohms as well. Unlike the factory speakers are 8ohms or somthing. I put 6.5" polk componants w/ tweeters up front and...

or run a Yakima mega warrior style basket on top of factory rails. I ran this setup before I got the Prinsu rack.

3D printing some cup holders

not the best res or even close but the screen is also low res so mute point. Used Pioneer NDBC8 wide view, decent night vision that is more grainy. Mounted direct to scuffed up 3rd brake light using the stock double sided tape, used same grommet as the 3rd light into the roof liner with silicon...

I swapped out the dead AHC in my truck for regular aftermarket bits. One less thing to worry about on these trucks. Lots on here have Ironman gear and yes to the Diff drop while you're in there, literally few bolts and it's installed.

finally wired in the the back up camera to the Kenwood deck. Mounted at on 3rd brake light for wider sky view angle, as I always have bike hitch on the truck. Also installed some Wells window visors. Nice sound improvement when windows are open too.

likely just blown out. My 01 had all speaker blown. I Replaced with Polk Audio running off Kenwood deck.