Recent content by jsager

Sold

price is $34,500 and sale is pending - odd the listing doesn't have a fill in blank for that critical part of the listing like the year/make/model/ODO etc.

Its an Aussie truck but the import was from Dubai (I did the import) - true KMs are unknown.

this is a 1994 Toyota Troopy HZJ 75 with 4.2-liter 1HZ diesel engine, 6 cylinder manual 5 speed with high and low range, automatic locking front hubs, fully insulated and noise deadened, interior subfloor built with new wall panels and fresh headliner. Has front seatbelts for 3, and 4 rear seats...

A head's up on the '04 in CA: Carfax shows consistent milage increases well into the 200k range then suddenly a registration at 60k.

its more @ Thread starterDA712 who's selling the truck who can't receive messages :/

Tried to send you a msg but your inbox is full....

Yeah…expanding threaded fasteners are certainly an option, we use those daily building vans, just not too excited about taking a 3/8” bit into that mangled hole of bolt bits and frame threads 🙈

That'll be tomorrow's project - try and remove all of the bolt material and then introduce new threads with the helicoil. I think the plate would do "fine" even without the cross member for "casual" skid plate usage, but that cross member certainly is needed if you plan to actually smash the...

I'm about to install mine ,and on mockup, realized that the middle skid's frame bolts for the subframe member had two broken (and well -seized) bolts left inside the frame. The front skid interferes with the ARB bumper, not a big deal to cut the aluminum away to fit against the bumper - but I am...

2” receiver mount is welded onto the swing out

headed around the corner to get some bread

I was replacing the telescoping motor on my 2000 LX and pulled the steering column out of its retaining sleeve, accidentally - it will go back in enough to drive but doesn't fully seat... Buying a replacement steering column is cheap ($150) but 4 times in a row the columns have been compressed...

Since its a LX470- its setup to telescope and tilt - if the standard one is compatible, that's a good back up option if I can't find the Lexus specific one. I have ordered 3 used ones and every time, its been shipped collapsed. Do you know if the 100 series would work in the LX?