Recent content by JPTX

PRICE REDUCED - $125 OBO!

Took these off to install my sliders. All brackets, electrical connections, and paint are in great shape. Price Reduced - Asking $125, local buyers only (Denver, CO)

OME 2860 Springs with approximately 10k miles on them, very little off-road use. I recently added a rear bumper with swingouts, 35" tire, hi-lift, etc, and it was too much weight for the 2860s to handle - swapped in some 2863s last week. Springs are in great shape and (obviously) have a ton of...

SCS tends to announce any pending re-stock via their Instagram account... If you don't hear back via email you could try contacting them via IG, but I wouldn't expect them to have a re-stock date for you. I have a set of these (and I like them), but I would recommend looking at some 17" wheels...

I know there are others with this bumper who aren't satisfied with the fog lights. From the driver's seat I couldn't tell if mine were on or off, even after putting in some LED bulbs. I decided to get some 2" cube LEDs and wire them to my fog lights switch. I used the existing holes in the...

Full set of OEM floor mats out of a 2002 LX. They're very clean, I just got a weathertech set to replace them. Includes the cargo area mat as well. Can post pictures later. $75 - just need them out of the garage Local pickup or meet up preferred as shipping probably won't be cheap.

I agree with @aging fleet - the "settling" doesn't take much more than a drive around the block. So, if you're happy with how everything looks after a short drive, there's no need to wait on the alignment.

Powder coated and mounted up! Thanks again @helocat for the Group Buy!

Stock UCAs off of my 2002 LX470 (taken off at 150k miles). I would recommend replacing the ball joints before installing them. Moving soon and need to get these out of the garage. Shipping is going to be about $30-50 depending on where they're going. Make me an offer!

Placed my order last night (raw sliders)! Anyone have paint recommendations??

@Roosevelt T that looks great! Would you mind posting a photo taken dead-on from the side so we can see the spacing between the tire carrier and the rear hatch/tailgate?

I ran my F5s with 285/75R16 and had a little rub - had to trim the "bump" on the fender liner (should have heated it up and reformed it instead). And the difference in offset in the F5s vs the stock wheels effectively makes for a 'built in' 2" spacer - more spacing won't help with anything...

Just wanted to say thank you to @Newps for the great write-up. Did this last week, no issues. I went the lazy route and skipped steps 2-7 (and got some nice bruising on my wrists as a result). Ordered the OEM t-stat and o-ring here for $20 total.

Dropping the asking price to $100

Shocks by Strutmasters for stock height 100 series. They ride very similarly to OEM shocks. They have 30k miles on them, and they still ride very nicely. If you need to replace your shocks but don't want to spend a lot/upgrade, this is a great deal. Includes all hardware/bushings. Located in...