I posted a few months ago debating between the LC and a Power wagon. I eventually picked up a older 200 with lower miles and opted to throw the additional cash at building the truck I wanted. Vehicle spent its life in Texas and is now in NM. This was instrumental when it came time for the...
Currently shopping for a new vehicle once I return to the States from being stationed overseas. Currently driving an 80 series 4.2 diesel. We've previously owned a tundra, 2 4Runners, and Ram 2500. Main use would be for overlanding, hunting, and some occasional towing.
I'm currently looking at...
Greetings, I'll be returning from be stationed overseas and am looking to purchase a lower mileage LC in late June.
Here is what I am looking for:
200 Series with no rust
Mileage <90K
Preferred colors – Black, Gray, Silver, White
Interior color - Black, Gray, or whatever the red/saddle...
That was the problem, didn't put grease on the bushing during reassembly. Is it normal for the bushing to contact the ABS gear on the bifilar if it is dry?
So I pulled the hub apart today and sure enough, it was the spindle bushing. I found shavings from the brass bushing as well as the front face of it being slightly chewed up as I assume it was coming in contact with the abs gear. I didn't have a spare bushing to replace nor the tool to pull the...
Thanks for the quick reply, the caliper had crossed my mind as the piston seals looked a bit aged. I did install new Toyota rotors and pads but don't recall the kit coming with any shims. I'll go back and look.
Hello,
Over the past couple of weeks I have rebuilt the passenger and driver side hubs on my '96 80 series. Initially, there were no issues but after a couple hundred miles, I have developed a moan from the left hub at low speeds in and out of turns up to about 10 mph, once I build up speed the...