Recent content by Johnny Boy

Catch can is also a nice-to-have if you install a watercooling system, to avoid to put oil in your heat exchanger (and lose efficiency). I'm using a Mann Provent 200 (I used a Flashlube Catch Can Pro before, but it was to small for our block size). Only issue, filters cost a lot and don't like...

I tested SuperiorEngineering one and same result on one side after 500km of tracks. I even lose the nut of the front diff housing bolt, due to vibration (hopefully I had one in spare with me because I was in the middle of nowhere in the Alps (and almost lost de bolt). All was well torqued and...

Hi, FYI in Europe we are using Racor FG500 filters on the 80 series (diesel), I guess it's ok for your use too.

Hi, as I will swap my mechanical winch by an electrical one, I had the idea to make this OBA setting too and I came across this topic. Could you review your setting after some years of use ? Do you have any pictures of it on your vehicle ? How do you reverse the output shaft, could you give me...

I just put a Redback4x4 extreme duty (AU) on mine, like the manta, it's an inside chassis one and very well done kit ;) I took the one with the resonator, it's sounds great (far better than OEM and quieter than straight pipe) :) Second choice was the Manta, but it was a little bit more...

Great, thanks, I love that kind of p&p stuff :)

Thank you for the info, I just ordered the RPAT-035 (the other was out of stock), new seals already received, look forward to testing this. Isn't the assembly too complicated, even if the design is not the same?

Found yesterday on mine... :censor:

It's here under your jack bottle mount ;)

FYI, issue solved for me. Wiring failed at 2 different spots : - Diff wiring : - Rear quarter panel wiring (wire was still in the plug, but not enough plugged) : Now rear diff works perfectly. However still one bad news : combination meter bulb from front diff has just failed (front diff...

As your front actuator is working fine (dashboard+actuator), remove the rear actuator (not a big job with fsm) and hook it up to the front wiring. If it works, you can refit the actuator and start to check the wiring. If it doesn't works, you can start to open/repair the actuator (btw actuator...

Did you already powered on directly your actuator ? Maybe check your wiring too. Mine (trailer wiring loom, located driver side as RDL wiring loom) was a bit burned when I purchase the vehicle. So I guess other wires are damaged too... ;)

I have the same issue (rear diff blinking but diff not locked - CDL + Front diff OK). - tried with another Diff ECU --> no change - tried to power directly the rear actuator --> OK, it works without issue So now I guess I have an issue with wiring.

Is there any bullbar compatible with a mechanical winch ? Because as long as your engine works (and you have spare pins), mechanical winch won't let you down :)

Is somebody know if ARB front bumper is compatible with OEM mechanical winch ?