Recent content by JohnJ7

2017 LC CA 15k

Shoutout to @duggy for installing my ARB front bumper, intensity lights, and warn winch. I'll be starting a thread soon detailing what I've done so far with my build and what future mods I'll be going for as well as the intended use of the vehicle. If you're in the Houston area and need any mods...

@jtv107 please share some pictures of the Kaymar rear bar install and final product if you go that route.

I’ve recently started hearing a grinding noise while steering at slow speeds (<10 MPH). I’m wondering if any of you have experienced this and what it could be. I found a video on YouTube that has the same issue in almost indentical situations. Any help would be appreciated!

Thank you all for the responses. @ckkone that's what I am looking for. For now, all I will need is a switch for the lights and a switch for the air compressor. Later down the road, I will need switches for lockers and even then I would still rather go with OEM style switches (I think they look a...

I am currently debating whether or not to install a switch panel solution for the accessories I will be installing. I prefer the factory look and would rather not install a panel and use the existing empty slots in the dash and install Toyota sized switches that I found on ch4x4. However, I do...

Thank you all for the advice. @fireball I am by no means an expert and this is my first build. My thought process was to isolate power draw of accessories from the main battery. The most I'd be stationary is one to two nights tops. That's the reason I asked the question. I am sure many on here...

I am currently planning the second phase of my build. The second phase will be to set up all the electrical components for my build. I've laid out all the major accessories I want to install like lighting, winch, fridge, air pump, lockers ect... and where I want their switches to be located...

@Taco2Cruiser Thank you

@Taco2Cruiser where can i buy the front and rear diff lock switches you have?

Someone recommended the Icon billet UCAs. It is also a uniball setup. I'm not sure I can justify the $500 difference in price. Is anyone running the Icon Billet UCA. Are there any specific benefits?

I want to get a feel of what UCAs people on here tend to go for and why?

Thank you! I appreciate your help

OME BP-51 285/65/R18 KO2 1.25” Spacers ARB Skids

1. I installed 2722 Springs just in anticipation of adding weight through drawers, and a rear bumper down the road. 2. I believe its still pre-loaded at 20mm. 3. I run 285/65/R18 KO2 at 47 PSI If I mess with the Compression and Rebound while staying at 20mm preload, will I be able to soften the...