Recent content by jhollander

As long as you are an Austin resident. You can go here and drop it off: Recycle and Reuse Drop-off Center | AustinTexas.gov - https://www.austintexas.gov/dropoff - super easy and free.

Remember - never negotiate with terrorist

@ptrsn Not sure where you're referencing. This is my shift knob. No screws. I assume if I want to unscrew the top it's just the whole section that turns

Longshot but anyone happen to have extra tumbler parts to rebuild an ignition lock? My ignition is hit and miss to be able to get it to turn (key goes in, then wont turn). Spraying it with lock lube (doesn't gum WD-40 basically) gets it to work for a start or two. Only place I'm finding the...

@MarkTR What did you end up doing here? Mine is in the same boat and on the fence as to rebuild it myself or go down the dealer/locksmith route

For transmission LCS sent me to the guys Eagle Transmission. Not going to win any customer service awards but they did at least tell me drive it till it blows or spend $4k and replace it now, we'd wait if it were us though (~2 years ago and still going)

no help but when i needed to replace my transfer case, I used the parting forum on here and was able to get hold of a used one pretty reasonable. might check there if you haven't yet

Following along. I installed HID recently and heard this noise. Wasn't sure if it was the ballast or something else. Edit: I should add it could have been there before I just hadn't had my head in the engine bay w/ key in on position

If I could do it all over again, I would go back and make sure I bought an 03 or newer to get the side airbags. Now that it's my daily and the kids are in it all the time, extra protection is not a bad thing. 200s are pretty, extra power and all the bells/whistles would be nice but I like the...

I'd be game. The LC group in Clubhouse area does meetings ~monthly too. Granted not just 100s (I think I'm the only one I've seen there) but fun to chat with everyone.

This is 100% accurate. Had to deal with it for my Model S right after getting it. There are third party “appraisers” you can use to help justify the diminished value. Good luck

Curious how folks are securing Jerry cans on the aluminum accessory tray. The description says it can be used for it and it has the holes cut out in the front and back. Are you just ratchet strapping left and right through the handles? Or is there an adaptor you need to secure them?

TL;DR - Anyone know their way around aiming headlights and willing to help me make my truck safe for night driving again? My '02 had original lights and were not as bright as I would have liked. Did some research and decided going with a HID conversion on Depo headlights was going to give me...

done.

In Houston Duggy's Garage is the place - @duggy In Austin go to Land Cruiser Specialist.