Recent content by Jake97T

Making progress. Waiting on my headgasket and drive plate bolts. Drive plate bolts didn’t come off too easy. Had to cut three off. Milwaukee impact has been nice for the front pulley on and off.

Great, ill bring it into the shop when i pick up the parts and see how it looks.

I have a new oil pump/timing cover. I didnt send it to the machine shop with the block and now wondering if i should have. I wasn't able to find any info. I mocked it up on the block before machine work and the top of the timing cover sat below the block. I am rebuilding my 1fzfe motor after a...

Sold

Built from a 95.5 Tacoma rear shaft.

After many many weekends. Desert sand monstaliner. Method wheels and 35" duratracs.

I have changed my caster and lift height thus I no longer require a double cardan front shaft. It is now for sale. Balanced and ready to install. No issues with joints. I ran this setup for approximately 30k. $250 free shipping lower 48. Much more expensive to source and build. Trying to post...

If they have to go through the effort to dolly any car or flat bed it's usually a bigger fee. So in the end your still the one that gets it in the end.

I installed depos last weekend. Used Slee harness. Currently running 55w high beams. They really do leave alot to be desired for performance. Now wishing I had jumpered the h4 high beams with the h1 beams.

I have 30mm spacers and 850s. I had to use the dbl. cardan shaft. I am in process of sourcing some OE bushings to replace my caster bushings for plates. (ARB front. 35s. 4.88)

Good to know shipping is reasonable.

I'm about to make the purchase of a bumper and tire carrier. Anyone else in Seattle area considering this as well. Would like to see about saving on shipping costs.

100 series front pads...vacuum pump the lines...way better pedal response and firmness compared to two person pump and hold methid.

I had the same symptoms but rear passenger. I tried the e Bay motors that others have tried. The worm gear was difficult to salvage and attach to the generic motor. But ultimately I had success with junk yard lock actuators.