Recent content by I Lean

  1. I

    Subwoofer, factory location/hidden

    Sent
  2. I

    Window Rocket - who’s tried it?

    All windows. And sunroof and seats, apparently. (I only care about the windows, the rest are bonuses)
  3. I

    Window Rocket - who’s tried it?

    I got mine today, install took 10 or 15 minutes. Speeded up the windows significantly...and I'm sure the difference will be even greater when it's cold. 😎 Before: After:
  4. I

    Subwoofer, factory location/hidden

    Sent.
  5. I

    Subwoofer, factory location/hidden

    Sent
  6. I

    Subwoofer, factory location/hidden

    I built it to fit my Rockford Fosgate PS8 so it obviously fits that one. Other people mounted Cerwin Vega and I think a Kicker as well? You're correct, you can't reasonably use the factory sub wiring. I can email the file to you. I'll just need an address. 😉
  7. I

    Princess Rig: Diesel Manual Troopy-Style Pop-top Conversion and Off to Adventure

    I can't confirm what one with running boards looks like, but mine is also open. (this is the driver's side, but it's open on the pass side as well)
  8. I

    Subwoofer, factory location/hidden

    Thanks for sending that. 🙂
  9. I

    DIY 20 gallon auxiliary fuel tank

    Yes, I used the S-10 fuel pump. That fuel sender also has a float to measure the fuel level in the tank, that's one of the things you hook up to the Apexus switch. The relay for the pump is so you don't try to have the fuel pump's full power running through the Apexus switch. If you can get...
  10. I

    Builds SupraCruza

    If you want to try again and make it slightly less temporary, cut the end of your tube at a 45 degree angle (or some other angle) before welding. That way it's not a straight-line weld HAZ. Also makes more welded area, which can't hurt. :)
  11. I

    Winch solenoid relocation

    Yes, just a simple sheet metal bracket. Bolts on with the single existing bolt to the core support, then bent down to catch the solenoid bolt holes.
  12. I

    Builds SupraCruza

    Pressurizing the brake caliper with compressed air works pretty well for welding brackets in place.
  13. I

    Builds SupraCruza

    What's going on with all the pulleys on your press?
  14. I

    Builds Benjamin’s 3D Prints Build

    Me too. I think it's currently out of the console, not in use.
  15. I

    I Like Big Brakes and I Cannot Lie!!!

    I have some before and after brake-test measurements in my thread here: Big brakes for the 80 - https://forum.ih8mud.com/threads/big-brakes-for-the-80.1186937/ Just for comparison's sake. Mine are not the same as any in this thread. (everything here is better, I wouldn't do mine again the...
See more
Back
Top Bottom