Recent content by HiLex

Short tube replace the original manifolds easier depending on the amount of exhaust work you want to do and emissions requirements long tubes will be more work and may not suffice the ECU O2 sensor inputs.

Call Jason at Burtman industries you don't need 10 people he can sell them as needed.

FOX 2.5 Extended travel front, Fox 2.0 Extended travel rear Toytec HD rear coils Total Chaos UCA's FN Wheels fX pro 17x8, 315/70/17 Nitto Terra Grapler MT . 3 inch suspension, 1 inch body lift custom coil conversion with Firestone airbags tied into factory load leveling system, Sway bars...

I don't have actual dyno numbers. Butt Dyno says he'll yes I also have a modified Volant intake and flow master high flow cats and a AFE cat back exhaust if I punch it off idle it wI'll break the tires loose a little and accelerates like a beast I'm in Denver and frequent the mountain trails low...

The inside of the headlight is a Matte Graphite, I tried the VHT but it just came out really glossy and almost black I didn't personally care for the glossy look in the light so I mixed up a color close to the stock grille the winch fairlead and prolink. The chrome in the stock headlight has a...

I tried to tint the chrome backing like the sport headlights but the green color of the light is actually the chrome, I used the VHT Night Shades to tint the housing and the orange reflector lens. Good luck its a fun project

I painted my headlights to match the grill and Factor 55 winch items, while I had the headlight apart the orange reflector pops right out so I tinted it. It still glows at night with the lights on just not as bright during the day I also put in HID 6000k lights and LED's while it was apart its...

I ca confirm what Matt said about the Gobi rack they are using my GX for the pattern and test fit I was over there last week and they took some measurements should hear back from them soon to test fit. They also have a GX460 rack in the works and they appear to be about the same dimensions...

I live in Colorado just recently passed visual and dyno smog inspection with spacers installed in both rear O2 sensors

Installing the DT headers requires a lot of patience and not being in a hurry I'm a very skilled mechanic builder I had 6 hours per side over a two day period during the weekend, also my GX has zero rust which can make it even more difficult I have heard of 4Runner guys having to cut the bolts...

Sorry I did not do a detailed write up on the Winch it was more a Fab and go type of thing I used 1/4 wall square tubing and 1/4 steel plate to mount to the frame at the bumper mounts I closed off the ends of the square tubing and welded a winch mount plate I got off Amazon I also have 2 mounts...

I'm in, looking forward to a good time.

I don't have any noticeable wind noise the Lexus is probably the quietest best insulated car I have ever owned that may help. I have a ExtremeLED 50" curved bar and they have rubber isolators that slide between the fins if you are getting harmonic noise.

Insain Fabrication is now making the light bar mounts for the GX mine is a prototype and now they have the mount for production Below is a link for their web site ask to talk to Derick or email him through the web site. The production model will be a little higher, mine barely clears the wipers...

I have a relay near the fusebox under the hood with a switch under the steering column. The light is grounded to the mount and the Hot wire runs along side the glass under the windshield trim.