I’ve been using a 105 arm for 8 years and haven’t seen issues. I can share pictures this weekend if it’s still unresolved, but something is off with the geometry if it rubs when level
Did you use the alignment marks on the box and 105 pitman arm? I recall not being able to use the marks due to interference and instead setting the 105 arm so the hole for the end is straight ahead.
I think it’s the combination of S13WB caliper with T100 rotor. I had a set on my 62 series LC. The cylinders in these calipers are larger than those in stock 60 series calipers
This thread discusses a 60 install of an aftermarket harness that only required a little work to be plugged and play
https://forum.ih8mud.com/threads/4-wire-trailer-plug-and-play-kit.846827/
There is an ignition switch, relay, and old wiring. Some Seattle cruiserheads are working through this issue now and one of them shared this diagram. This is for a 60
US LHD 62s have a dash lights dimmer and rear mirror control between steering and driver door. Could it be either of these? The fuse panel is also on this side with the door facing forward
There is an opening on the back of the wheel where you can access the adjuster. You may have a rubber cap in yours if it’s in good shape. You can poke a screwdriver in there and press it against the star wheel to move it up/down to change tension on the shoes. I don’t recall loosening direction...
Nice work!
Did the wiring harness they provided have extra connectors that you didn’t need to use?
The same unit seems to apply to all years LCs and LXs, but I know from nav delete threads that there were several variants in nav configurations. I’m curious if they created a universal wiring...