Recent content by fst aslp

I did the BiLED in both the high and low beams. Tremendous output. I did have to slightly adjust the level of one of them, but I am very happy it took about 11 weeks to get them, but were responsive through the entire process. I'd recommend them for sure.

I can add a bit of info as I just installed mine a few weeks ago. Output- forget about it, so bright and sharp. I went with the dual projector option. I didn't add any halos or other options. They sent it in Koito housings (Plastic) Install was very straight forward and they were super...

Thanks for doing this!

I have run into an issue with the Yakima rack and I am hoping someone can shed some light: @alpinecowboy @digitalmarker I see these hoops mentioned in the roof rack instructions- I don't see them in my kit or on my truck. Am I missing something? I am thinking they are 63452b and...

Darn, looks like they show as not available now.

This is what I am going to run. I am likely going to cut off the 4pin connectors and solder to take out one failure point.

Yes it does- it’s on the list to be removed. It also had it on the high mount stop- but had to replace that due to a crack and a leak.

Swapped my BBS’s on and added spacers. Next up: wheel bearings, AHC refresh and DT headers.

It is at the 4 second mark of the video- pulsing vibration sound.

I promised I searched every ‘sound’ descriptor I could think of. To me it sounds like a bull frog in the drivers side of the engine bay. It happens most when I come to a stop- but it is cyclical and I can hear a faint relay click. This leads me to believe it isn't a heat shield. All skid...

Did you ever resolve? Mine is making a similar noise. Still very faint

Gonna drive it for however long it will let me. It’s come a long way in a few days. Looking forward to sorting it all out.

275/70/18 and tundra wheels installed today

Another pic