Recent content by Eric Greno

My 96 has sensors that look like the one on the right.

i don't think that gaskets/o-ring swells

10-4

If he isn't interested, I'm in Mobile, AL and am looking for boards and brackets

If this was a straight future swap into my 96 I would come and get it. Im in Mobile. good luck!

My 96 is doing the same thing, loudest decel noise was front u joints. I still have the rear u joint to change and it will hopefully eliminate the rest of the noise. 2.5" lift in mine when I got it. It also to me goes along with the driveshaft moving in and out.

I am chasing down past due maintenance on a 1996 80 with an OME lift. I am now down to the crazy noise during deceleration. I am changing all of the U joints, but it is a crazy angle out of the transfer case that I think is the noise culprit. I feel as though it is going to eat a new U joint...

I repeatedly questioned it why some idiot put those radiator nuts behind the headlight

Square hole and breaker bar

I cut a square hole and used a 3/4 inch breaker bar against the frame

I drove my FJ40 for about 2 months with a cracked cylinder head on 3 cylinders till spring break (time to fix it) early 90s and poor college student. Granted, non electric engine but basically the same. Stick some antifouling plug adapters on it and use it til it breaks.

I just did mine today. I made a plate to hold the harmonic balancer out if a 1/2" sheet of fiberglass. Worked great.

A little more info, vehicle runs and drives great, no shift problems, not cooling issues. I havent driven 100 miles since I picked it up because is was the original radiator and one of the two water pump belts was gone and the other one was coming apart! Everything I have noticed with it...

I picked this up a few months back to restore for daily driver. I have owned fj40s for 30+ years. Finally got wife projects to a point to start doing long term maintenance. I have pink milkshake in the cooling system. Found while pulling original radiator for future replacement. Going to do...